Re: module parport_pc lsst sich nicht laden
Elimar Riesebieter said:
> Hi,
>
> I am running a selfmade 2.4.19. The printer devive isn't available:
> modprobe parport_pc
> /lib/modules/2.4.19/kernel/drivers/parport/parport_pc.o:
> init_module: Device or resource busy
> Hint: insmod errors can be caused by incorrect module parameters,
> ^^^^^^^^^^^^^^^^^^^^^^^^^^^?
> including invalid IO or IRQ parameters
> ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ ?
> /lib/modules/2.4.19/kernel/drivers/parport/parport_pc.o: insmod
> /lib/modules/2.4.19/kernel/drivers/parport/parport_pc.o failed
> /lib/modules/2.4.19/kernel/drivers/parport/parport_pc.o: insmod
> parport_pc failed
>
> Any Hints?
I'm no expert on 2.4.x, and have been curious why this message comes
up(I see it on SuSE 8 which uses 2.4.18 ..)
at least for this SuSE 8 system here to get parport_pc to load I have
to specify the IRQ and io address. with kernel 2.2.x it doesn't seem
to care ........
e.g.
modprobe parport_pc io=0x378 irq=7
the above parameters are usually the defaults for the parallel port
on most systems.. check the bios of your system to be sure if it doesn't
work ..
nate
Reply to: