[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: SCSI HDD Problem



On Fri, 2002-07-26 at 21:54, Choe, Hyun-ho wrote:
> I use QDI LegenX IV Dual-Celeron 440LX board.
> It has on-board AIC-7880 Ultra SCSI host adapter.
> 
> My dmesg is:
> 
> Jul 27 08:03:11 jason kernel: SCSI subsystem driver Revision: 1.00
> Jul 27 08:03:11 jason kernel: ahc_pci:0:11:0: Illegal cable configuration!!.
> Only two connectors on the adapter may be used at a time!
> Jul 27 08:03:11 jason kernel: scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA
> DRIVER, Rev 6.2.4
> Jul 27 08:03:11 jason kernel:         <Adaptec aic7880 Ultra SCSI adapter>
> Jul 27 08:03:11 jason kernel:         aic7880: Ultra Wide Channel A, SCSI
> Id=7, 16/253 SCBs
> Jul 27 08:03:11 jason kernel:
> Jul 27 08:03:11 jason kernel:   Vendor: IBM       Model: IC35L018UWD210-0
> Rev: S5BS
> Jul 27 08:03:11 jason kernel:   Type:   Direct-Access
> ANSI SCSI revision: 03
> Jul 27 08:03:11 jason kernel: (scsi0:A:0): 20.000MB/s transfers (10.000MHz,
> offset 8, 16bit)
> Jul 27 08:03:11 jason kernel: scsi0:A:0:0: Tagged Queuing enabled.  Depth
> 253
> Jul 27 08:03:11 jason kernel: Attached scsi disk sda at scsi0, channel 0, id
> 0, lun 0
> Jul 27 08:03:11 jason kernel: SCSI device sda: 35843670 512-byte hdwr
> sectors (18352 MB)
> Jul 27 08:03:11 jason kernel: Partition check:
> Jul 27 08:03:11 jason kernel:  sda: sda1 sda2 sda3 < sda5 sda6 sda7 sda8 >
> 
> 1. Why "Illegal cable configuration!!. Only two connectors on the adapter
> may be used at a time!" message is displayed?
> My SCSI BIOS termination is set to "automatic" and HDD side termination
> jumper was properly set.
> In kernel 2.2 I had no problem, but in kernel 2.4, I've got above message.
> 
> 2. I think transfer speed should be 40MB/s(20MHz). Is there any scsi
> checking tool or method?

There are two different modules for that card, maybe try a 'the other
one' 'scsiinfo' is one tool available.


CONFIG_SCSI_AIC7XXX=m
CONFIG_AIC7XXX_CMDS_PER_DEVICE=8
CONFIG_AIC7XXX_RESET_DELAY_MS=15000
# CONFIG_AIC7XXX_BUILD_FIRMWARE is not set
CONFIG_SCSI_AIC7XXX_OLD=m

-- 
Greg C. Madden
Debian GNU/Linux 3.0

Attachment: signature.asc
Description: This is a digitally signed message part


Reply to: