Re: CD-ROM doesn't mount w/ 2.4.18
hi ya mark
- check your cables... keep it straight as reasonably possible
- use the short ata-66/100 ide cables ( 18" or less )
- cables should have ground between the signals
80 conductors vs 40...
- use one disk per cable... do NOT mix and match ide speeds
ata-33 on one cable
ata-66 on a different cable
ata-100 on a 3rd cable...
... dont mix um up....
- since its the cdrom that is timing out... its probably that
the system is talking ot it at ata-66/100 speeds insteadof ata-33
c ya
alvin
http://www.Linux-1U.net/Disks ... ide - scsi stuff ...
On Sun, 10 Mar 2002, Mark wrote:
>
>
> Has anyone seen something like this when trying to mount their CD-ROM with
> some of the latest kernel releases?
>
> hdc: status error: status=0x58 { DriveReady SeekComplete DataRequest }
> hdc: drive not ready for command
> hdc: status timeout: status=0xd0 { Busy }
> hdc: DMA disabled
> hdc: drive not ready for command
> hdc: ATAPI reset complete
> hdc: irq timeout: status=0x80 { Busy }
> hdc: ATAPI reset complete
> hdc: irq timeout: status=0x80 { Busy }
> end_request: I/O error, dev 16:00 (hdc), sector 124
> ISOFS: unable to read i-node block
>
>
> I was able to mount the same drive and same CD in 2.2.19 with no problems.
>
Reply to: