Re: eth0 (previously - pcmcia)
On Tue, Feb 19, 2002 at 12:22:31PM -0800, Vaughan, Curtis wrote:
>Ok, everyone can forget my letter (FW: pcmcia). I've got my card working
>now. But now I don't know how to do the following.
>
>After I installed the appropriate module, I knew the card was working
>because of the IP traffic diode. Previously, this would only light up after
>configuring eth0. I can enter ifconfig eth0 up (or down), but it makes no
>difference. I can seem to peg an ip address to it either. What's going on?
>
Really help if you sent the output of ifconfig eth0 with the appropriate settings. As it is, we don't know what you've actually tried.
Patrick
Reply to: