Re: Upgraded X to 4.1: Lost 1280x1024 mode
On Thu, Nov 15, 2001 at 03:06:18PM -0800, Bill Wohler wrote:
> Dust the modelines. X 4.1 doesn't need them any more (yay!). Make
> sure that your VertRefresh and HorizSync lines are at the maximum
> values allowed by your monitor.
>
I have put in the maximum values (found them from the manual).
Still no luck.
> If the mdetect and read-edid packages are present, the debconf
> scripts in this package will use them to attempt automatic
> configuration of your mouse and monitor.
>
Running potato. So, downloaded the sources and compiled them.
Installed them. Configuration is much easier. But still I do not get
the 1152x864 screen.
A portion of my new XF86Config-4:
Section "Monitor"
Identifier "SAM:3610"
HorizSync 31.5-60
VertRefresh 50-100
Option "DPMS"
EndSection
The modeline portion of my earlier config that would work:
# 640x480 @ 100 Hz, 53.01 kHz hsync
Modeline "640x480" 45.8 640 672 768 864 480 488 494 530 -HSync -VSync
# 800x600 @ 85 Hz, 55.84 kHz hsync
Modeline "800x600" 60.75 800 864 928 1088 600 616 621 657 -HSync -VSync
# 1024x768 @ 70 Hz, 56.5 kHz hsync
Modeline "1024x768" 75 1024 1048 1184 1328 768 771 777 806 -hsync -vsync
# 1152x864 @ 60 Hz, 53.5 kHz hsync
Modeline "1152x864" 89.9 1152 1216 1472 1680 864 868 876 892 -HSync -VSync
#
As the frequencies are within the specified range, I feel that I
should get the resolutions. But I do not. Is there something that we
are missing?
Thanks,
--
Sridhar M.A. mas@uomphysics.net
Your happiness is intertwined with your outlook on life.
Reply to: