Re: IRQ conflict on ethernet cards
* Eric Smith (Eric.Smith@fruitcom.com) wrote:
> I have a RealTek and a 3com card which are both sharing the same irq
> viz. /proc/interrups:
>
> I did all I could on the simplistic CMOS that I have but I cannot
> allocate IRQ specifically to ports. I also ran the reltek dos
> diagnostics and setting utility and all is fine but I cannot
> change the IRQ from 10 with it.
Eric, I had such a problem and solved it by changing the IRQ on a 3Com
card. Their diagnostics and install floppy works wonders in most cases.
Have you tried that one? This is the way that I've seen advised on this
list many times.
Alex.
-----------------------
Oleksandr Moskalenko
malex@purdue.edu
-----------------------
pub 1024D/6C5F196B 2001-08-17 /* http://www.tagancha.org/pgp */
Oleksandr V. Moskalenko (Alex) <malex@tagancha.org>
Fingerprint = EE63 C471 ADBA 5D80 ADFB 1054 DA28 6F32 6C5F 196B
----------------------------------------------------------------
Reply to: