|
Ok,i played a little more and look where i
am:
setserial /dev/ttyS2 shows irq 2,port 0x0110 and uart
16450..till now it was uart unknown.This is set with:
setserial /dev/ttyS2 irq 9 port 0x0110 uart
16450
if i start minicom it says initializing modem,then stays
like this 3,4 seconds then it prints out a long line of
"yyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyy".After i Ctrl+a x for exit it
hangs!
wvdialconf searches through ttyS0,ttyS1 and ttyS2 without
finding something,
wvdial finally doesn't say i/o error anymore and it prints
out:
-> Initializing modem
-> Sending: ATZ
-> Modem not responding
Now,once again i have an internal isa US Robotics modem at
14400..
What next?
Could it be the uart type? or the initialization
string?
where can i search and modify these?
Thx,
Dani.
|