Re: FW: D-Link DFE-530TX+ via-rhine.o module
On Mon, Mar 19, 2001 at 01:26:31AM -0800, David Carlile wrote:
| Thanks for the quick reply.
|
| I tried modconf and selected rtl8193. I didn't include any parameters. I got
| an error message: "Device or resource busy. Hint: this error can be caused
| by incorrect module parameters, including invalid IO or irq parameters."
|
| Any ideas?
I think that browsing /proc/pci can give some information, but I
haven't tried that yet. Have you used the card in windows? What does
it report as the IRQ and IO addresses?
| BTW, I checked the card and the link light is on, which kind of suprises me
| because I didn't think I had a driver loaded... Is it possible a driver was
I would expect the link light to be on if you have the card plugged
into the service (or cable modem) because a link exists. If you
unplug the card from the network the link light will go off. This is
hardware independent of the software drivers. It is a convenient way
to get information about which part of the card isn't working. My
card (LinkSys) has link, 100, duplex, and tx lights to indicate if a
link (network) exists, the network is 100 Mbps, the network is full
duplex, the card is transfering data right not.
-D
Reply to: