Re: Getting to the GUI...
Quoting Rick Commo (Rick.Commo@verizon.net):
> (3) In XF86Free I have tried each and every given monitor as well as
> entering in the hsync and vsync as 30-58 and 50-90 respectively.
It looks from the output as if you may have modelines that are far
too ambitious. I don't know XF86Free or where it gets them from.
> (**) Mach64: Graphics device ID: "ATI"
> (**) Mach64: Monitor ID: "Icon"
> (--) Mach64: Mode "640x480" needs vert refresh rate of 100.02 Hz. Deleted.
That looks as if it's deleting
# 640x480 @ 100 Hz, 53.01 kHz hsync
modeline "640x480" 45.8 640 672 768 864 480 488 494 530 -HSync -VSync
where you might use one of
# 640x400 @ 70 Hz, 31.5 kHz hsync
modeline "640x400" 25.175 640 664 760 800 400 409 411 450
# 640x480 @ 60 Hz, 31.5 kHz hsync
Modeline "640x480" 25.175 640 664 760 800 480 491 493 525
# 640x480 @ 72 Hz, 36.5 kHz hsync
Modeline "640x480" 31.5 640 680 720 864 480 488 491 521
# 640x480 @ 75 Hz, 37.50 kHz hsync
Modeline "640x480" 31.5 640 656 720 840 480 481 484 500 -HSync -VSync
Similarly
> (--) Mach64: Mode "800x600" needs hsync freq of 64.02 kHz. Deleted.
looks as if it's deleting
# 800x600 @ 100 Hz, 64.02 kHz hsync
modeline "800x600" 69.65 800 864 928 1088 600 604 610 640 -HSync -VSync
where you might use one of
# 800x600 @ 72 Hz, 48.0 kHz hsync
Modeline "800x600" 50 800 856 976 1040 600 637 643 666 +hsync +vsync
# 800x600 @ 85 Hz, 55.84 kHz hsync
modeline "800x600" 60.75 800 864 928 1088 600 616 621 657 -HSync -VSync
and so on.
Cheers,
--
Email: d.wright@open.ac.uk Tel: +44 1908 653 739 Fax: +44 1908 655 151
Snail: David Wright, Earth Science Dept., Milton Keynes, England, MK7 6AA
Disclaimer: These addresses are only for reaching me, and do not signify
official stationery. Views expressed here are either my own or plagiarised.
Reply to: