lp problems, with iomega ZIp pass through on parallel port

[Gregory Guthrie <guthrie@mum.edu>]

I have an Iomega zip on the parallel port, and unless I power it off at 
boot time, I cannot seem to see the printer that is chained through it. O 
recall that there was a module for this, can someone give a pointer?

Thanks,
Greg Guthrie

--------------------------------------------------------
Dr. Gregory Guthrie
guthrie@mum.edu         (515)472-1125    Fax: -1103
       Computer Science Department
       College of Science and Technology
       Maharishi University of Management
      (Maharishi International University 1971-1995)
        http://www.mum.edu/cs_dept
--------------------------------------------------------