Sound not working
I just installed kernel 2.2.18 (with IDE patches) on a Woody box and now
my sound is not working.
I have a soundblaster Live!
My previous kernel was 2.4-test-11 and sound worked fine with the driver
compiled into the kernel. I compiled the driver into the 2.2.18 kernel
and I can see it loads the driver on boot up, but the /dev/dsp and
/dev/mixer devices are empty and /proc has no audio devices listed.
Any ideas what could be causing this? If I boot with my 2.4-test-11
kernel sound works fine again.
My kernel output is given below
Thanks for any help anyone may have!
Kelly
Linux version 2.2.18 (root@funkmotor) (gcc version 2.95.2 20000220
(Debian GNU/Linux)) #3 Fri Dec 15 11:22:48 CST 2000
Detected 598633 kHz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 1196.03 BogoMIPS
Memory: 127896k/131008k available (1132k kernel code, 416k reserved,
1516k data, 48k init)
Dentry hash table entries: 16384 (order 5, 128k)
Buffer cache hash table entries: 131072 (order 7, 512k)
Page cache hash table entries: 32768 (order 5, 128k)
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
256K L2 cache (8 way)
CPU: L2 Cache: 256K
CPU: Intel Pentium III (Coppermine) stepping 01
Checking 386/387 coupling... OK, FPU using exception 16 error reporting.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.35a (19990819) Richard Gooch (rgooch@atnf.csiro.au)
PCI: PCI BIOS revision 2.10 entry at 0xfd993
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Enabling I/O for device 00:70
PCI: Enabling I/O for device 00:71
Linux agpgart interface v0.99 (c) Jeff Hartmann
agpgart: Maximum main memory to use for agp memory: 94M
agpgart: Detected Intel 440BX chipset
agpgart: AGP aperture is 64M @ 0xf8000000
Linux NET4.0 for Linux 2.2
Based upon Swansea University Computer Society NET3.039
NET4: Unix domain sockets 1.0 for Linux NET4.0.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
TCP: Hash tables configured (ehash 131072 bhash 65536)
Starting kswapd v 1.5
Detected PS/2 Mouse Port.
Serial driver version 4.27 with no serial options enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
pty: 256 Unix98 ptys configured
Real Time Clock Driver v1.09
Creative EMU10K1 PCI Audio Driver, version 0.7, 18:05:59 Dec 14 2000
emu10k1: EMU10K1 rev 7 model 0x8022 found, IO at 0x1040-0x105f, IRQ 10
Uniform Multi-Platform E-IDE driver Revision: 6.30
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PIIX4: IDE controller on PCI bus 00 dev 39
PIIX4: chipset revision 1
PIIX4: not 100% native mode: will probe irqs later
ide1: BM-DMA at 0x1008-0x100f, BIOS settings: hdc:DMA, hdd:pio
PDC20262: IDE controller on PCI bus 00 dev 78
PDC20262: chipset revision 1
PDC20262: not 100% native mode: will probe irqs later
PDC20262: (U)DMA Burst Bit ENABLED Primary PCI Mode Secondary PCI Mode.
ide0: BM-DMA at 0x1400-0x1407, BIOS settings: hda:DMA, hdb:DMA
ide2: BM-DMA at 0x1408-0x140f, BIOS settings: hde:pio, hdf:DMA
hda: WDC WD204BA, ATA DISK drive
hdc: CRD-8480C, ATAPI CDROM drive
hdd: CREATIVE CD-RW RW4224E, ATAPI CDROM drive
ide0 at 0x1068-0x106f,0x101e on irq 3
ide1 at 0x170-0x177,0x376 on irq 15
hda: WDC WD204BA, 19470MB w/2048kB Cache, CHS=39560/16/63, UDMA(66)
hdc: ATAPI 48X CD-ROM drive, 128kB Cache, UDMA(33)
Uniform CD-ROM driver Revision: 3.11
hdd: ATAPI 24X CD-ROM CD-R/RW drive, 1860kB Cache
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
3c59x.c 15Sep00 Donald Becker and others
http://www.scyld.com/network/vortex.html
eth0: 3Com 3c905C Tornado at 0x1080, 00:50:da:19:62:6e, IRQ 11
8K byte-wide RAM 5:3 Rx:Tx split, 100baseTX interface.
Enabling bus-master transmits and whole-frame receives.
Partition check:
hda: [PTBL] [2482/255/63] hda1 hda2 hda3
[drm] AGP 0.99 on Intel 440BX @ 0xf8000000 64MB
[drm] Initialized tdfx 1.0.0 20000719 on minor 63
Creative EMU10K1 PCI Audio Driver, version 0.7, 18:05:59 Dec 14 2000
P6 Microcode Update Driver v1.05 registered
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 48k freed
Adding Swap: 136544k swap-space (priority -1)
/dev/vmmon: Module vmmon: registered with major=10 minor=165 tag=$Name:
build-799 $
/dev/vmmon: Module vmmon: initialized
/dev/vmnet: open called by PID 834 (vmnet-bridge)
/dev/vmnet: hub 0 does not exist, allocating memory.
/dev/vmnet: port on hub 0 successfully opened
bridge-eth0: up
bridge-eth0: attached
--
--------------------------------------------
-- Kelly Corbin
-- kcorbin@theiqgroup.com
--
-- On the web @ http://www.theiqgroup.com
-- The IQ Group, Inc.
-- 6740 Antioch Suite 110
-- Merriam, KS 66202
-- (913)-722-6700 x105
-- Fax (913)722-7264
--------------------------------------------
Reply to: