Re: LILO 1024 error
Read /usr/share/doc/lilo/Manual.txt.gz. and put a new line
in your lilo.conf immediately after the delay line:
lba32
With this, lilo as of version 1:21.4.2 now supports booting
from above cylinder 1024 (~8 GB).
I have a 13GB hd and my lilo boots o/s any where on
my hd.
On Wed, 11 Oct 2000 17:10:58 +0900, Jack Morgan said:
> Sorry if this has been discussed before,
>
> I can't get lilo to boot a windows partition which is after the 1024 cylinder.
> I beleive that now it is able to, but...not sure how?
> My lilo.conf is setup as follows:
>
> boot=/dev/hda
> root=/dev/hda5
> install=/boot/boot.b
> map=/boot/map
> vga=normal
> delay=20
> image=/vmlinuz
> label=Linux
> read-only
> other=/dev/hda3
> table=/dev/hda
> label=Windows
>
> Thanks in Advance...
> --
> Jack Morgan Debian GNU/Linux
> Email: j-morgan@gol.com
> Web-site: www.mandinka.org
--
gEEk||dOOd^Deb+ian&&XFce$everything goes<Pronto>(-_-)
Reply to: