[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: LILO 1024 error



	Just realized that windows probably should be first on
your hd and then use lilo as i described below.

> 	Read /usr/share/doc/lilo/Manual.txt.gz. and put a new line
>  in your lilo.conf immediately after the  delay line:
>  lba32
>  	With this,  lilo as of version 1:21.4.2 now supports booting
>  from above cylinder 1024 (~8 GB).
>  	I have a 13GB hd and my lilo boots o/s any where on
>  my hd.
>  
>  On Wed, 11 Oct 2000 17:10:58 +0900, Jack Morgan said:
>  
>  > Sorry if this has been discussed before,
>  >  
>  >  I can't get lilo to boot a windows partition which is after the 1024 cylinder.
>  >  I beleive that now it is able to, but...not sure how? 
>  >  My lilo.conf is setup as follows:
>  >  
>  >  boot=/dev/hda
>  >  root=/dev/hda5
>  >  install=/boot/boot.b
>  >  map=/boot/map
>  >  vga=normal
>  >  delay=20
>  >  image=/vmlinuz
>  >          label=Linux
>  >          read-only
>  >  other=/dev/hda3
>  >  table=/dev/hda
>  >  label=Windows
>  >  
>  >  Thanks in Advance...
>  >  -- 
>  >  Jack Morgan			Debian GNU/Linux
>  >  Email:				j-morgan@gol.com
>  >  Web-site:			www.mandinka.org
>  
>  
>  -- 
>  gEEk||dOOd^Deb+ian&&XFce$everything goes<Pronto>(-_-




Reply to: