[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: 3c509 troubles



Hello!

Maybe, it could be a "normal" hardware resource conflict. But, why is the
module loaded properly although the card has a conflict? I think, the card
has a resource conflict, but the 3c509 module doesn't detect it. When
ifconfig wants to configure the interface, it therefore cannot succeed. Hmm,
as I said, the card works absolutely ok in pnp mode in my machine, but if
you use jumperless, but non-pnp mode, you maybe have to assign the resources
to this isa card in bios. In pnp mode, it could be possible that it has to
be configured with isapnp (but not at my machine :)). Just write me some
more about your hardware settings, maybe some interrupt and i/o listings
from /proc and we'll see.

Regards,

Stephan Hachinger



----- Original Message -----
From: "Jan- Hendrik Palic" <jhp@operating.netuse.de>
To: "Stephan Hachinger" <Stephan.Hachinger@gmx.de>
Sent: Monday, October 02, 2000 9:37 PM
Subject: Re: 3c509 troubles


>
>
> Stephan Hachinger schrieb:
> >
> > Hello!
> >
> > I've also got a 3c509b and it works fine. I switched on PnP mode in the
> > DOS-based "3com utilites" setup program and then you don't really have
to do
> > anything complicated any more, because the bios automatically assigns
> > irq/dma. Perhaps, there's just another pnp card using the interrupt of
the
> > 3com and this could be changed by switching the 3com to pnp. And: You've
got
> > to compile and install the kernel module for 3c509, it normally is able
to
> > autodetect irq, i/o etc.. For the irq etc... configuration, you could
use
> > isapnp, but it doesn't seem to be necessary for this card. I never used
> > linux 3c...setup in my life.
> >
> Hi Stephan...
>
> I've the card, too. My problem is, that, the module for this card is
> loaded succesfully and dmesg says:
>
> eth0 3c509 ....
>
> so, I thing, the device eth0 is enabled.
>
> But:
>
> "ifconfig etho 192.168.252.10 netmask 255.255.255.0" returns, that the
> resources is temprarily in use!
>
> But why..
>
> any suggestions?
>
> thnx
>
> Jan
>
> PS.:
>
> Please sent a cc to my private adress: palic@billgotchy.de, thnx..
>
>
> --
> ---Aus dem Noc---
> Jan- Hendrik Palic
> Mail: palic@billgotchy.de
> Url : http://www.billgotchy.de
> PGP : Key:  2048bit id: 9AEF805D create: 2000/03/28
>       Sign: Jan- Hendrik Palic <palic@billgotchy.de>
>       Fingerprint = C7 CE E3 16 10 B8 DE B8  8D 54 03 E6 E7 1A 16 6C
>



Reply to: