R: CD R/W no CD present?
> I have been trying to get mu HP9200 SCSI CD R/W working. The
> CD is identifed
> at boot. I have:
> sg.o
> sr_mod.o
> ide-scsi.o (although I don't think I need it)
no, you don't need it since your HP is scsi. maybe this can make a little
confusion ..
.. if you load it. if you don't, all you need should be sr_mod and sg.
unless you have an ide cdrom. in this case, i'm a little bit lost, but i
know there's an howto about it.
> set as modules.
>
> When I run cdrecord -scanbus the CD Writer is again
> identified but when I
have you tried cdrecord on the command line to burn cds?
i know nothing about xcdroast, but used cdrecord quite a bit.
cdrecord want a special syntax for devices, usually a triple x,y,z, where,
IIRC
x is scsi host, y is scsi-id for cdburner, and z is scsi lun (usually 0)
> Also, how do I mount the CD Writer to read CD's as I would a
> normal CD?
no, you should use /dev/scd0 a la
mount -t iso9660 -o ro /dev/scd0 /cdwrite
(if /cdwrite exists)
HTH (a little bit)
Marco Frattola (S3 - Sviluppo Software e Sistemi) -
Cubecom S.p.A.
Via de Marini,1 3 piano Torre WTC
16149 GENOVA
tel. 010 6591184
Reply to: