Re: 3COM905B 10/100 Ethernet Config
On Tue, 8 Feb 2000, Todd Suess wrote:
tsuess >does not
tsuess >seem to be sensed at all, and no eth0 device gets created. I can do a
tsuess >lspci on the
tsuess >card, and this is the output, if that is helpful at all.
try using the linux drivers at www.3com.com i have the same card in a few
machines, a couple of them run dual 3c905b(VPN machines), had to use the
3com drivers(kernel 2.2.10)
Bus 0, device 8, function 0:
Ethernet controller: 3Com Unknown device (rev 116).
Vendor id=10b7. Device id=9200.
Medium devsel. IRQ 10. Master Capable. Latency=64. Min
Gnt=10.Max Lat=10.
I/O at 0xe800 [0xe801].
Non-prefetchable 32 bit memory at 0xe8401000 [0xe8401000].
Bus 0, device 9, function 0:
Ethernet controller: 3Com 3C905B 100bTX (rev 48).
Medium devsel. IRQ 11. Master Capable. Latency=64. Min
Gnt=10.Max Lat=10.
I/O at 0xec00 [0xec01].
Non-prefetchable 32 bit memory at 0xe8400000 [0xe8400000].
the 3com driver includes a patch for 2.2.5 which is what i used i believe,
it patched cleanly on 2.2.10 if i remember right(havent done it since
early december) using v1.0.0
nate
----------------------------------------[mailto:aphro@aphroland.org ]--
Vice President Network Operations http://www.firetrail.com/
Firetrail Internet Services Limited http://www.aphroland.org/
Everett, WA 425-348-7336 http://www.linuxpowered.net/
Powered By: http://comedy.aphroland.org/
Debian 2.1 Linux 2.0.36 SMP http://yahoo.aphroland.org/
-----------------------------------------[mailto:aphro@netquest.net ]--
8:49am up 172 days, 21:02, 1 user, load average: 1.11, 1.08, 1.08
Reply to: