Re: minicom: remote echo
typically this is turned on in the modem itself via AT commands, this
particular behavior is usually modem-specific, so check your manual, if
you dont have one you can look at
http://www.firetrail.com/~aphro/atmodem.pdf which is a AT command set
manual, couple hundred pages long. on an external USR sportster i have
here having the modem echo commands is set via a dip switch.
nate
On Wed, 12 Jan 2000, Aaron M. Johnson wrote:
amj >Hello,
amj > I have a modem which responds to AT commands within minicom
amj >but does not display the return codes, i.e. OK, BUSY, NO CARRIER. I
amj >am able to dialout but cannot write scripts for mgetty until the modem
amj >remote echo displays *something*. Turning on local echo does display
amj >the input I type, but the remote echo displays nothing. I've tried
amj >two modems both external: Motorola Lifestyle 28.8 (model 3400), and
amj >Pratical Peripherals 336 minitower. Both have 25 pin outputs and I
amj >have tried to hook them up to both a 9 pin and 25 pin serial port.
amj >
amj >Wondering if anybody has come across this modem state. What did you
amj >do to fix it?
amj >
amj >thank you,
amj >aaron
amj >
amj >uname -a
amj >Linux aura 2.0.38 #1 Wed Jan 12 13:56:48 GMT 2000 i586 unknown
amj >running potato...
amj >
amj >dpkg -l shellutils minicom
amj >Desired=Unknown/Install/Remove/Purge
amj >| Status=Not/Installed/Config-files/Unpacked/Failed-config/Half-installed
amj >|/ Err?=(none)/Hold/Reinst-required/X=both-problems (Status,Err: uppercase=bad)
amj >||/ Name Version Description
amj >+++-===============-==============-============================================
amj >ii shellutils 1.16-6.3 The GNU shell programming utilities.
amj >ii minicom 1.82.1-1 Clone of the MS-DOS "Telix" communications p
amj >
amj >stty -a < /dev/ttyS0
amj >
amj >speed 115200 baud; rows 0; columns 0; line = 0;
amj >intr = ^C; quit = ^\; erase = ^?; kill = ^U; eof = ^D; eol = <undef>;
amj >eol2 = <undef>; start = ^Q; stop = ^S; susp = ^Z; rprnt = ^R; werase = ^W;
amj >lnext = ^V; flush = ^O; min = 1; time = 5;
amj >-parenb -parodd cs8 hupcl -cstopb cread clocal -crtscts
amj >ignbrk -brkint -ignpar -parmrk -inpck -istrip -inlcr -igncr -icrnl -ixon -ixoff
amj >-iuclc -ixany -imaxbel
amj >-opost -olcuc -ocrnl -onlcr -onocr -onlret -ofill -ofdel nl0 cr0 tab0 bs0 vt0
amj >ff0
amj >-isig -icanon -iexten -echo -echoe -echok -echonl -noflsh -xcase -tostop
amj >-echoprt -echoctl -echoke
amj >
amj >
amj >/dev/ttyS1 is disabled in the BIOS due to conflict with 3c509
amj >
amj >dmesg
amj >Serial driver version 4.13p1 with no serial options enabled
amj >ttyS00 at 0x03f8 (irq = 4) is a 16550A
amj >
amj >cat /proc/interrupts
amj > 0: 280478 timer
amj > 1: 3796 keyboard
amj > 2: 0 cascade
amj > 3: 2029 3c509
amj > 4: 310 + serial
amj >13: 1 math error
amj >14: 14599 + ide0
amj >
amj >cat /proc/ioports
amj >0000-001f : dma1
amj >0020-003f : pic1
amj >0040-005f : timer
amj >0060-006f : keyboard
amj >0080-008f : dma page reg
amj >00a0-00bf : pic2
amj >00c0-00df : dma2
amj >00f0-00ff : npu
amj >01f0-01f7 : ide0
amj >0210-021f : 3c509
amj >03c0-03df : vga+
amj >03f0-03f5 : floppy
amj >03f6-03f6 : ide0
amj >03f7-03f7 : floppy DIR
amj >03f8-03ff : serial(set)
amj >f000-f007 : IDE DMA
amj >f008-f00f : IDE DMA
amj >
amj >
amj >
amj >--
amj >Unsubscribe? mail -s unsubscribe debian-user-request@lists.debian.org < /dev/null
amj >
----------------------------------------[mailto:aphro@aphroland.org ]--
Vice President Network Operations http://www.firetrail.com/
Firetrail Internet Services Limited http://www.aphroland.org/
Everett, WA 425-348-7336 http://www.linuxpowered.net/
Powered By: http://comedy.aphroland.org/
Debian 2.1 Linux 2.0.36 SMP http://yahoo.aphroland.org/
-----------------------------------------[mailto:aphro@netquest.net ]--
3:28pm up 146 days, 3:28, 2 users, load average: 0.27, 0.32, 0.28
Reply to: