Help with HP CD-writer 7100
I am trying to get the beast to work but I am unsuccessful anyone out
there know how to get it to work so I can record CD's?
I get the following messages during booting
----------------------------------------------------------------------------
paride: epat registered as protocol 0
pcd: pcd version 1.07, major 46, nice 0
pcd0: Sharing parport0 at 0x378
pcd0: epat 1.01, Shuttle EPAT chip c6 at 0x378, mode 5 (EPP-32), delay 1
pcd0: Slave: CD-Writer+ 7100
pg: pg version 1.02, major 97
pg0: Sharing parport0 at 0x378
pg0: epat 1.01, Shuttle EPAT chip c6 at 0x378, mode 5 (EPP-32), delay 1
pg0: HP CD-Writer+ 7100, slave
imm: Version 2.03 (for Linux 2.0.0)
imm: Found device at ID 6, Attempting to use EPP 32 bit
imm: Communication established with ID 6 using EPP 32 bit
scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.1.20/3.2.4
<Adaptec AIC-7880 Ultra SCSI host adapter>
scsi1 : SCSI host adapter emulation for IDE ATAPI devices
scsi2 : Iomega VPI2 (imm) interface
scsi : 3 hosts.
(scsi0:0:0:0) Synchronous at 20.0 Mbyte/sec, offset 15.
Vendor: SEAGATE Model: ST52160N Rev: 0285
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 0, id 0, lun 0
Vendor: IOMEGA Model: ZIP 100 Rev: P.04
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi removable disk sdb at scsi2, channel 0, id 6, lun 0
scsi : detected 2 SCSI disks total.
SCSI device sda: hdwr sector= 512 bytes. Sectors= 4238282 [2069 MB] [2.1
GB]
SCSI device sdb: hdwr sector= 512 bytes. Sectors= 196608 [96 MB] [0.1 GB]
sdb: Write Protect is off
...
-------------------------------------------------------------------------------
I have read all the howto's I could and still no where near getting it to
write anything on the disk.
Any help?
/------------------------------------------------------------------------------/
Daniel J. Mashao
Electrical Engineering daniel@eng.uct.ac.za
University of Cape Town http://www.ee.uct.ac.za/~daniel
Rondebosch, 7700, S. Africa (w) 27+21+650 2816 (h) 27+21+705 8469
/------------------------------------------------------------------------------/
Reply to: