udma66 ...

[Jean-Yves BARBIER <jybarbier@wanadoo.fr>]

Hi all,

I installed a 2.2.12 kernel and the hedridck patch for udma66;
I had:
	append="mem=127M ide2=0x1e8,0x3ee,11"

in /etc/lilo.conf, but I still have problems; detection is well done 
BUT not for the good drive:

PIIX4: IDE controller on PCI bus 00 dev 39
PIIX4: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:DMA, hdb:pio
    ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:DMA, hdd:pio
HPT366: onboard version of chipset, pin1=1 pin2=2
PCI: HPT366: Fixing interrupt 11 pin 2 to ZERO
HPT366: IDE controller on PCI bus 00 dev 98
HPT366: not 100% native mode: will probe irqs later
    ide3: BM-DMA at 0xbc00-0xbc07, BIOS settings: hdg:DMA, hdh:pio
hda: Maxtor 91728D8, ATA DISK drive
hdc: Maxtor 91080D5, ATA DISK drive
hdg: IBM-DJNA-351520, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
ide3 at 0xb400-0xb407,0xb802 on irq 11
hda: Maxtor 91728D8, 16479MB w/512kB Cache, CHS=2232/240/63, UDMA(33)
hdc: Maxtor 91080D5, 10300MB w/512kB Cache, CHS=20928/16/63, UDMA(33)
hdg: IBM-DJNA-351520, 14664MB w/430kB Cache, CHS=29795/16/63, UDMA(66)
Floppy drive(s): fd0 is 1.44M

Why does the 3rd HD's on /dev/hdg, instead of /dev/hde?????
and why does the speed (hdparm -t ..) still the same than under
udma33? (and I'm sure that udma66 is Ok on this drive, through the
dos utility).

So, at this point, I must say: "AAAAAArrrrrrggHHHHH @@^|[{^#!!,"

Thanks in advance,

JY
-- 
Jean-Yves F. Barbier <jybarbier@wanadoo.fr>
 [FORTRAN] will persist for some time -- probably for at least the next decade.
		-- T. Cheatham