Re: Debian/Slink Connection Speed...too slow

[Ed Cogburn <ecogburn@greene.xtn.net>]

Salman Ahmed wrote:
> 
> >>>>> "DCL" == Dwayne C Litzenberger <dlitz@cheerful.com> writes:
> 
>     DCL> Edit /etc/ppp/peers/provider and make sure your baud rate is set
>     DCL> to 115200 or 57600.  You might also want to add the lines:
> 
>     DCL>   bsdcomp 15,15 deflate 15,15 vj-max-slots 16
> 
>     DCL> To juice up compression.
> 
> Thanks for the tip. I also added the following lines after reading the pppd
> man page:
> 
>    asyncmap 0
>    mru 576
>    mtu 576


	I too use the mtu and mru above.  However FYI, the 'asyncmap 0' is
redundant since its also enabled in /etc/ppp/options (on potato system
at least).


-- 
Ed C.