Re: eth0: unknown interface...
Hugo van der Merwe <hugo@mailroom.com> writes:
> > I have installed the debian base system on a laptop, but now I need to
> > install the rest over a network (from another brilliant working Debian
> > machine). For this to work, I must get the pcmcia network card working...
>
> I just realised, I think I didn't make use of the menu item "Configure
> PCMCIA Support". Is there an easy way of configuring PCMCIA support for
> installation once I've already installed the base system? Can I run
> dbootstrap again? Where do I get it (the boot disks aren't mountable,
> right?) Or is it easier to reinstall from scratch?
Please have a look at pcnetconfig(8) part of pcmcia-cs.
(Sorry I don´t use pcmcia, this turned up using
zgrep config Contents-i386.gz |grep pcmcia)
HTH,
Jens
--
P.S.: Please vote against Spam! At
http://www.politik-digital.de/spam/
(Sorry Europeans only)
---
Jens.Ritter@weh.rwth-aachen.de grimaldi@debian.org
Key ID: 2048/E451C639 Jens Ritter
Key fingerprint: 5F 3D 43 1E 24 1E CC 48 1E 05 93 3A A7 10 73 37
Reply to: