configure for SoundBlaster cdrom sbpcd.h ?
As the system is booting up, it eventually gets to this...
sbpcd-0 [01]: sbpcd.c v4.6 Eberhard Moenkeberg <emoenke@gwdg.de>
sbpcd-0 [02]: Scanning 0x340 (LaserMate)...
sbpcd-0 [03]: Scanning 0x230 (SoundBlaster)...
sbpcd-0 [04]: Drive 0 (ID=0): CR-563 (0.75) at 0x230 (type 1)
sbpcd-1 [05]: You should read linux/Documentation/cdrom/sbpcd
sbpcd-1 [06]: and then configure sbpcd.h for your hardware.
sbpcd-0 [07]: data buffer size: 8 frames.
I tried adding,
sbpcd=0x230,1 and sbpcd=0x230,SoundBlaster into /etc/lilo.config
but got the same result.
I tried to make sense of the suggested documentation
along with the cdrom and bootpromt HOWTO's and the lilo manual,
but apparently Im still confused about this.
Could somebody please suggest what needs to be configured and where,
in order to circumvent the autoprobing for the cdrom drive.
Please send your reply to senders
email address otherwise I'll miss it.
_______________________________________________________________
DO YOU YAHOO!?
Get your free @yahoo.com.au address at http://mail.yahoo.com.au
Reply to: