Re: slink install messed up hamm partition
Hi, Brandon
Sorry I didn't see your message sooner. What I ended up doing is reverting the
slink setserial back to the hamm one, and that took care of the problem. I
think I'll leave well enough alone, but will save your message for a future
attempt.
Thanks
John B
Brandon Mitchell wrote:
> On Sat, 13 Feb 1999, John Bagdanoff wrote:
>
> > So I don't get the SETSERIAL not found anymore on bootup, but I still
> > have to reset the irq to 3 before I reconnect to my isp before every
> > session.
> >
> > I thought at first this change of behavior was due to installing slink
> > from my hamm partition, but I also upgraded most of my hamm to slink
> > packages at about the same time. What might I have changed to make
> > /dev/ttS2 to revert back to irq 4 all the time? I plan to pull out my
> > modem and change the jumper setting, but before I do that, I'd like to
> > understand why this is happening.
>
> This has happened to me. Just add "serial" to /etc/modules. If you
> don't, serial is autoloaded whenever you need it, but with the default
> values. After a while, it is unloaded again, unless you have this line in
> your /etc/modules.
>
> HTH,
> Brandon
>
> +--- ---+
> | Brandon Mitchell bmitch@atdot.org http://bmitch.nws.net/ ICQ 30631197 |
> | Throughout history, UNIX systems have regulary been broken into, beaten, |
> | brutalized, corrupted, commandeered, compromised, and illegally fscked. |
> | -- UNIX System Administration Handbook |
Reply to: