Re: How to change IRQ on NIC?
Excellent! That did it.
FYI, I couldn't just change the config; I had to remove the module and then
add it right back in, changing the parameters at that point.
One more question; after making a change like that, can you get the system
to see the change without rebooting? I suspect you can, but I don't know
how, so I just rebooted, which worked fine. But I'd like to know for future
reference.
Thanks again!
At 03:38 PM 7/23/1998 -0600, you wrote:
>On Thu, 23 Jul 1998, Kent West wrote:
>
>> I'm sure this is SOMEWHERE in the documentation, but I'm not finding it.
>> How do I change the IRQ on my network card in hamm? I've just installed it
>> on a laptop/docking station, and forgot to check my IRQ first, so I guessed
>> at 10 during the install. That was wrong; I need to change it to 15. How do
>> I do this?
>
>Going into modconf and changing details for the NIC module should allow
>you to change the IRQ. Hope this helps.
>
>
>
>
>--
>Unsubscribe? mail -s unsubscribe debian-user-request@lists.debian.org <
/dev/null
>
===========================================================
Kent West | Technology Support/Customer Service |
Abilene Christian University | Voice: 915-674-2557 FAX: 915.674.6724 |
ACU Station, Box 29005 | E-MAIL: kent.west@infotech.acu.edu |
Abilene, TX 79699-9005 | Ham: KC5ENO, General |
===========================================================
--
Unsubscribe? mail -s unsubscribe debian-user-request@lists.debian.org < /dev/null
Reply to: