X problems
Dear all,
I got X setup OK (using XF86Setup), and then set start-xdm in the config
file, but xdm dies horribly (from the error log):
(--) Mach64: Mode "1024x768" needs hsync freq of 35.57 kHz. Deleted.
<a bit later>
(--) Mach64: There is no mode definition named "1024x768"
Fatal server error:
No valid modes found.
Now my XF86Config file:
Section "Monitor"
Identifier "Primary Monitor"
VendorName "Unknown"
ModelName "Unknown"
HorizSync 31.5-31.5,35.15-35.15,35.5-35.5
VertRefresh 55-90
Modeline "1024x768" 44.96 1024 1048 1208 1264 768 776 784 817 +hsync
+vsync interlace
EndSection
These were all made by XF86Setup, and indeed it worked OK when Setup ran
it's little auto-test.
So why doesn't it work now? and indeed, would fiddling the HorizSync rate
be OK or am I going to blow my monitor?
Matthew
--
Elen sila lumenn' omentielvo
Steward of the Cambridge Tolkien Society
Selwyn College Computer Support
http://www.geocities.com/Area51/Chamber/8841/
http://www.cam.ac.uk/CambUniv/Societies/tolkien/
http://pick.sel.cam.ac.uk/
Reply to: