hd parameters at boot up
When I boot my system I have to tell the kernel
the hard drive parameters.
LILO: linux hda=1010,12,55 hdb=683,16,38
I would like to get this set up so I don't have
to manually enter this information.
I tried setting up my lilo.conf file as follows:
boot=/dev/hda
delay = 100
root=/dev/hda2
compact
install=/boot/boot.b
map=/boot/map
vga=normal
read-only
disk=/dev/hda
cylinders=1010
heads=12
sectors=55
disk=/dev/hdb
cylinders=683
heads=16
sectors=38
image=/vmlinuz
label=linux
image=/vmlinuz-old
label=old
Then I ran 'lilo'
However I still have to enter the parameters manually.
What am I doing wrong here?
thanks
Brad
______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com
Reply to: