Re: low throughput on PPP link
At 09:35 AM 6/2/98 -0500, Jens B. Jorgensen wrote:
>> > >Well, you need to pass the speed to pppd as 115200, not 57600. You
see, the
>> > >set_serial spd_vhi flag sets what speed will be used if 38400 is
selected.
>> > >However, pppd can set the speed to 115200 just fine if you specify
it. You're
>> > >specifying 57600 and that's what you're getting.
-- Does this mean;
1) setting 115200 is independent of any setting of {normal,hi,vhi}, or s
there an interaction, and thus only certain valid pairs.
2) Is the report of Baud-base rate from "seterial -a" the bottom line, it
says 115200 and normal.
lrouter# setserial -a /dev/ttyS0
/dev/ttyS0, Line 0, UART: 16550A, Port: 0x03f8, IRQ: 4
Baud_base: 115200, close_delay: 50, divisor: 0
closing_wait: 3000, closing_wait2: infinte
Flags: spd_normal skip_test session_lockout
But, "stty -a < /dev/ttyS0" says baud = 57600.
If so, I still wonder why we are only getting ~< 56K throughput..
Thanks.
Gregory Guthrie
--
To UNSUBSCRIBE, email to debian-user-request@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
Reply to: