IBM Token Ring Card [does not work]
Hello all !
I' trying to configure a IBM Token Ring card with Debian GNU/Linux.
I have built the kernel with Token Ring support, and have the IBM Tropix
driver built as a module. Now look whats happening, when I try to use the
card.
----------------------------------------- root session transscript follows -
[kermit:/root] insmod ibmtr
ibmtr.c: v1.3.57 8/7/94 Peter De Schrijver and Mark Swanson
modified 10/3/94 DW Morris, modified at VIA, ECP, France
(3/9/95 F Farid and P Andre, 9/7/95 PA and 2/20/95 ML/PA/YD)
tr0: ISA adapter found using irq 9, PIOaddr a20, 16K shared RAM.
tr0: Hardware address : 08:00:5A:AA:BF:55
tr0: Initial interrupt : shared RAM located at 000D02D4.
tr0: Adapter initialized and opened.
[kermit:/root] ifconfig tr0 192.234.10.55 netmask 255.255.255.0 broadcast 192.234.10.255
[kermit:/root] ifconfig
lo Link encap:Local Loopback
inet addr:127.0.0.1 Bcast:127.255.255.255 Mask:255.0.0.0
UP BROADCAST LOOPBACK RUNNING MTU:3584 Metric:1
RX packets:60 errors:0 dropped:0 overruns:0
TX packets:60 errors:0 dropped:0 overruns:0
eth0 Link encap:10Mbps Ethernet HWaddr 00:80:29:E6:AC:B2
inet addr:131.234.10.53 Bcast:131.234.10.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:188 errors:0 dropped:0 overruns:0
TX packets:70 errors:0 dropped:0 overruns:0
Interrupt:5 Base address:0x340
tr0 Link encap:16/4 Mbps TR HWaddr 08:00:5A:AA:BF:55
inet addr:192.234.10.55 Bcast:192.234.10.255 Mask:255.255.255.0
UP BROADCAST RUNNING MTU:2000 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0
TX packets:0 errors:0 dropped:0 overruns:0
Interrupt:9 Base address:0xa20
[kermit:/root] route add -net tok
[kermit:/root] route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
eth * 255.255.255.0 U 0 0 1 eth0
tok * 255.255.255.0 U 0 0 1 tr0
localnet * 255.0.0.0 U 0 0 0 lo
[kermit:/root] ping 192.234.10.10
tr0: Unknown command 02 in arb
tr0: Arrg. Transmitter busy for more than 50 msec. Donald resets adapter, but resetting
the IBM tokenring adapter takes a long time. It might not even help when the
ring is very busy, so we just wait a little longer and hope for the best.
[... and so on ... nothing happens only this message is repeated ...]
-------------------------------- end of session transscript --------------
I have tested two cards (one 8 bit ISA and one 16 bit ISA) and none works.
The 16 bit card works fine in an other PC with SCO Unix.
I'm not a real unix hacker, so could please anyone tell what I should do
next ???
Tnx in advance!
Bye
Daniel
--------------------------------------------------------------------------
Daniel Gross eMail: dg@bingo.baynet.de
Hollarstrasse 2 dgross@gmx.net
D-85053 Ingolstadt, Germany
--------------------------------------------------------------------------
Boucher's Observation:
He who blows his own horn always plays the music
several octaves higher than originally written.
--
TO UNSUBSCRIBE FROM THIS MAILING LIST: e-mail the word "unsubscribe" to
debian-user-request@lists.debian.org .
Trouble? e-mail to templin@bucknell.edu .
Reply to: