Re: Diald & modem forget irq #
Hi Will,
did you perhaps compile the serial driver as a module? If so the
behaviour is quite clear. When the serial module is unloaded the
hardware configuration, i.e. IRQ and IO is lost. Upon reloading the
module the default values are used. Consequently, the solution could be
to compile the serial driver into the kernel rather than as a module.
Regards,
Andree
--
| Institute of Geophysics phone: +49 40 4123 4389
ANDREE LEIDENFROST | University of Hamburg fax: +49 40 4123 5441
Geophysicist | Bundesstrasse 55 e-mail: leidenfrost@dkrz.de
| D-20146 Hamburg www: www.app-geoph.dkrz.de
--
TO UNSUBSCRIBE FROM THIS MAILING LIST: e-mail the word "unsubscribe" to
debian-user-request@lists.debian.org .
Trouble? e-mail to templin@bucknell.edu .
Reply to: