Linux kernel V. 2.0.27 does not boot; SCSI-trouble
Dear Linux-friends,
I am using a 486-VLB-System with an Adaptec AHA2842 (2xHDD (id0 and
id1), 1xCDROM (id 2)) and I cannot install the Debian-distribution
V.1.2.8 because the kernel
V. 2.0.27 does not boot. I have a lot of older kernels and they all
boots fine on my machine.
The following messages are the last I can read on the screen when the
system stops (SHIFT-PGUP does not work). Who can help and explain what
goes wrong.
.
.
.
scsi: 1 host
scsi0: Scanning channel A for devices
scsi: aborting command due to timeout:
pid 0, scsi 0, channel 0, id 0, lun 0,
Test Unit Ready 00 00 00 00 00
aic7xxx: (abort) Aborting scb 0, TCL 0/0/0
scsi: aborting command due to timeout:
pid 0, scsi 0, channel 0, id 0, lun 0,
Test Unit Ready 00 00 00 00 00
aic7xxx: Aborting scb 0, TCL 0/0/0
SCSI host 0 abort (pid 0) timed out-resetting
SCSI bus is reset for host 0 channel 0
aic7xxx: (reset) target/channel 0/0
aic7xxx: (abort_reset) scb state 0x1, while idle,
LASTPHASE=0x9e SCSISIGI=0x0
aic7xxx: (reset_device) target/channel -1/A, active_scb 0
aic7xxx: (match_scb) comparing target/channel -1/A to scb 0
aic7xxx: (match_scb) comparing target/channel -1/A to scb 0
aic7xxx: (reset_channel) Resetting current channel A
aic7xxx: (reset_channel) Channel reset, sequencer restarted
aic7xxx: (done_aborted_scbs) Aborting scb 0 TCL=0/0/0
scsi0: BRKADRINT error (0x1)
Illegal host address
Kernel panic: SCSI 0: BRKADRINT, error 0x1, seqaddr 0x0
not syncing - in swapper task
--
TO UNSUBSCRIBE FROM THIS MAILING LIST: e-mail the word "unsubscribe" to
debian-user-request@lists.debian.org .
Trouble? e-mail to templin@bucknell.edu .
Reply to: