RE: ppp redial problem
On Fri, 11 Apr 1997, Rick wrote:
> -----BEGIN PGP SIGNED MESSAGE-----
>
> Why don't you try adding a wait or sleep command to the chatscript just
> before the dialout, or try a comma (,) between the numbers to see if it
> helps. It may be just sending the data too fast.
>
> Also. Normally at&f doesn't reset the modem. It resets FACTORY DEFAULTS
> which can be off the wall and slow down or stop it from functioning properly
> until you get a good init string in it. ATZ re-initializes it to previous
> settings. AT&V will show you a list of the current settings on the modem.
> This is if it uses the Hayes command set (Hayes compatable).
>
Thanks I will try these suggestions. Based on my reading of the manual
at&f should have reinitialized the modem too but I or the manual could be
wrong. As I mentioned before, minicom works fine so my guess is still
there is something wrong in my pppd setup.
-- Jaldhar
Reply to: