ppp
hi,
what's the the best init string to pass on to a 14.4 plug n' pray
USRobotics modem?
and i got this errors:
ppp0 Link encap:Point-Point Protocol
inet addr:xxx.xxx.xxx.xxx P-t-P:xxx.xxx.xxx.xxx Mask:255.255.255.0
UP POINTOPOINT RUNNING MTU:1500 Metric:1
RX packets:14 errors:7dropped:7 overruns:0
TX packets:22 errors:0 dropped:0 overruns:0
what does this mean? i have a 16550a uart chip. and the speed is 19200,
and i even lowered the mtu to 500 and it's still the same :(. What happens
is, i could connect fine, but say, after a few minutes, i got cut off.
And it's not the telephone line bacause this computer is a dual boot
debian and windoz95 computer. In windoz, it works fine.
any comments and suggestions?
tia,
Andre --
Reply to:
- Follow-Ups:
- Re: ppp
- From: Mike Leddy <mike@ultranet.com.br>
- References:
- Re: BO
- From: <tomk@westgac3.dragon.com>