Re: HELP: Probs configuring X
Run the program xvidtune, tune your monitor to look like you want it to,
and then push the "Show" button. Copy the output from xvidtune to the
/etc/X11/XF86Config to replace the current settings for the adjusted
video modes.
-Erik
--
Erik B. Andersen Web: http://www.et.byu.edu/~andersee/
2485 South State St. email: andersee@et.byu.edu
Springville, Ut 84663 phone: (801) 489-1231
--This message was written using 73% post-consumer electrons--
Justin Stodola wrote:
>
> Ok, X works ok, with one annoying problem: Down the left hand
> side of the screen is a fairly narrow(~.25 inch) band of increased
> intensity that makes anything that fall within it unreadable. This
> occurs in all video modes with resolutions higher than 640x480.
>
> My hardware:
> STB Powergraph 64 Video(S3 Trio64V+ Chipset)
> MAG DX17F Monitor(30-64kHz Horizontal, 50-100Hz Vertical)
>
> I am using the xserver-s3, and configured for the S3 Trio64 chipset.
>
> Anyone have any suggestions?
>
> Justin Stodola
> Senior-Physics Dept. U of Ky
> jestod00@pop.uky.edu
> jestod00@mik.uky.edu
Reply to: