Re: [Linux] Re: NVIDIA WideScreen Sorunu
Merhaba,
Şu anda sorunu çözdüm ama pek hoşuma da gitti denemez. Sizin
dediklerinize çıkıyor ama sanırım..
NVIDIA'nın README'sinde şunlar yazıyor:
Installation and configuration of the NVIDIA Accelerated Linux Driver
Set on a laptop is the same as for any desktop environment, with a few
minor exceptions, listed below.
Starting in the 1.0-2802 release, information about the internal flatpanel
for use in initializing the display is by default generated on the fly
from data stored in the video BIOS. This can be disabled by setting
the "SoftEDIDs" kernel option to 0. If "SoftEDIDs" is turned off, then
hardcoded data will be chosen from a table, based on the value of the
"Mobile" kernel option.
The "Mobile" kernel option can be set to any of the following values:
0xFFFFFFFF : let the kernel module auto detect the correct value
1 : Dell laptops
2 : non-Compal Toshiba laptops
3 : all other laptops
4 : Compal Toshiba laptops
5 : Gateway laptops
Again, the "Mobile" kernel option is only needed if SoftEDIDs is
disabled; when it is used, it is usually safest to let the kernel
module auto detect the correct value (this is the default behavior).
Should you need to alter either of these options, this can be done by
doing any of the following:
o editing os-registry.c in the usr/src/nv/ directory of the
.run file.
o setting the value on the modprobe command line (eg: `modprobe
nvidia NVreg_SoftEDIDs=0 NVreg_Mobile=3`)
o adding an "options" line to your module configuration file,
usually /etc/modules.conf (eg: "options nvidia
NVreg_Mobile=5")
NVIDIA sürücüsünü (7174) derleyip kurduktan sonra:
modprobe nvidia NVreg_SoftEDIDs=0 NVreg_Mobile=3
yazınca sorunsuz olarak açıldı. Şimdi bu satırı Debian'ın açılışına
ekleyeceğim.
Yardımlarınız için teşekkür ederim.
begin:vcard
fn:Alper KANAT
n:KANAT;Alper
adr;quoted-printable:;;;Istanbul;;;T=C3=9CRK=C4=B0YE
email;internet:tunix@raptiye.org
url:http://raptiye.org
version:2.1
end:vcard
Reply to: