PCI NE2000
Dear friends,
I am Amaia and I work in Ikerlan in the Basque Country.
We have bought a PC/104 embedded board from Eurotech with the
following characteristic:
* Flash disk (DiskOnChip).
* Hard disk.
* Floppy driver.
We have installed a Red Hat Linux version 6.0 on the hard disk of this
board.The Kernel we have installed is the 2.0.38. We also have an Ethernet
PCI board (NE2000). I like to install this network board but I have some
problems.
The Steps I have followed for the installation are listed next:
1.-I have configured Linux with the 'make menuconfig' command and I
have choosen my Ethernet card.
2.-I have compiled de Kernel doing 'make dep', 'make clean' and
'make zImage'.
3.-I have created a new start disk by copying the zImage file I have
just created.
I think that it is not neccessary to do anything else but when I reboot the
system it doesn't detect my Ethernet board, Why?
I would be very gratefull if you could help me.
Best Regards,
AMAIA
> Amaia Egidazu<AEgidazu@ikerlan.es>
> Company address:
> Ikerlan
> Phone 34-43-712400
> Fax 34-43-796944
> P.O. Box 146
> 20500 Mondragon-Gipuzkoa
> SPAIN
>
>
>
Reply to: