Re: Kernel 2.6.6 e CDROM
Oi! se nao estiver tarde demais pra responder, o Dmesg dele indica
que o kernel esta usando "devfs" por isso os nomes de dispositivos sao
diferentes do que a gente ta' acostumado. se ele nao usava o "DevFS" ele
pode retirar o suporte do kernel (compilado a partir dos fontes do
kernel.org ) pois o "DevFS" e' considerado obsoleto nos kerneis da serie
2.6.x em diante (agora o povo parece que ta' usando hotplug ou algo
parecido :-)
Gerson Henrique Diesel wrote:
Vamos lá:
PCI: Using ACPI for IRQ routing
Simple Boot Flag at 0x72 set to 0x1
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
++++++++++++++++++++++++++++++++++++
devfs: 2004-01-31 Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x0
^^^^^^^^^^^^^^^^^^^^^^^++++++++++++++
>scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.36
<Adaptec 29160B Ultra160 SCSI adapter>
aic7892: Ultra160 Wide Channel A, SCSI Id=7, 32/253 SCBs
Using anticipatory io scheduler
(scsi0:A:0): 160.000MB/s transfers (80.000MHz DT, offset 63, 16bit)
Vendor: IBM-ESXS Model: ST318305LW !# Rev: B244
Type: Direct-Access ANSI SCSI revision: 03
scsi0:A:0:0: Tagged Queuing enabled. Depth 8
Attached scsi generic sg0 at scsi0, channel 0, id 0, lun 0, type 0
SCSI device sda: 35548320 512-byte hdwr sectors (18201 MB)
SCSI device sda: drive cache: write back
/dev/scsi/host0/bus0/target0/lun0: p1 p2 < p5 p6 p7 >
^^^^^^exemplo de DevFS pra HD Scsi:-) pra Ide e'diferente:-)
Reply to: