[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: pl rede

Ola pessoal,

Tambem estou com problemas para configurar minha placa de rede. No meu caso, eh uma placa SiS900 onboard na asus p4s8x-x. Ao iniciar e ao tentar configura-la com o etherconf, tenho o seguinte erro:

eth0: ERROR while getting interface flags: No such device

Ao dar um ifconfig eth0:

eth0: error fetching interface information: Device not found

com lspci -v (cortando o que interessa):

00:04.0 Ethernet controller: Silicon Integrated Systems [SiS] SiS900 10/100 Ethernet (rev 91)
        Subsystem: Asustek Computer, Inc.: Unknown device 80a7
        Flags: bus master, medium devsel, latency 32, IRQ 3
        I/O ports at 9800 [size=256]
        Memory at dd000000 (32-bit, non-prefetchable) [size=4K]
        Expansion ROM at efee0000 [disabled] [size=128K]
        Capabilities: [40] Power Management version 2
 

com dmesg | grep eth0 inicialmente nao retorna nada. Ao usar o kudzu, ele retorna:

eth0: Realtek RTL8201 PHY transceiver found at address 1.
eth0: Using transceiver found at address 1 as default
eth0: SiS 900 PCI Fast Ethernet at 0x9800, IRQ 3, 00:0c:6e:44:09:3b.

Mas mesmo assim continua nao funcionando.


Obrigado
Alexandre Martani


Em Sun,  7 Mar 2004 01:30:15 -0300 (BRT)
linuser <linuser@uol.com.br> escreveu:

> 
> At 01:08 6/3/2004 -0300, you wrote:
> >quando dá lspci aparece somente Realtek 10/100 Mbps Ethernet PHY ?
> 
> Bom, pessoal, apaguei o enorme thread que estava anexo, e recomecei
> novamente  a mensagem. O que ocorre com o dispositivo de rede é que 
> não funciona.
> Tenho os seguinte dados:
> 
> 1-o dispositivo ethernet é onboard (placa asus a7v8xx)
> 
> 2- um lspci -v resulta no seguinte (cortei coisas que não interessam):
> 
> 00:12.0 Ethernet controller: VIA Technologies, Inc. Ethernet > Controller (rev 74)
> 	Subsystem: Asustek Computer, Inc.: Unknown device 80a1
> 	Flags: bus master, stepping, medium devsel, latency 32, IRQ 9
> 	I/O ports at b000 [size=256]
> 	Memory at f0800000 (32-bit, non-prefetchable) [size=256]
> 	Capabilities: [40] Power Management version 2
> 
> 3- um ifconfig -a resulta no seguinte:
> 
> lo        Link encap:Local Loopback  
>           inet addr:127.0.0.1  Mask:255.0.0.0
>           UP LOOPBACK RUNNING  MTU:16436  Metric:1
>           RX packets:36 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:36 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:0 
>           RX bytes:2363 (2.3 KiB)  TX bytes:2363 (2.3 KiB)
> 
> 4- o arquivo de configuração do kernel (.config) contém, na seção
> correspondente a dispositivo ethernet, o seguinte:
> 
> ***** INICIO DO .config   ********
> #
> # Ethernet (10 or 100Mbit)
> #
> CONFIG_NET_ETHERNET=y
> # CONFIG_SUNLANCE is not set
> CONFIG_HAPPYMEAL=m
> # CONFIG_SUNBMAC is not set
> # CONFIG_SUNQE is not set
> CONFIG_SUNGEM=m
> CONFIG_NET_VENDOR_3COM=y
> CONFIG_EL1=m
> CONFIG_EL2=m
> CONFIG_ELPLUS=m
> CONFIG_EL16=m
> CONFIG_EL3=m
> CONFIG_3C515=m
> # CONFIG_ELMC is not set
> # CONFIG_ELMC_II is not set
> CONFIG_VORTEX=m
> CONFIG_LANCE=m
> CONFIG_NET_VENDOR_SMC=y
> CONFIG_WD80x3=m
> # CONFIG_ULTRAMCA is not set
> CONFIG_ULTRA=m
> # CONFIG_ULTRA32 is not set
> CONFIG_SMC9194=m
> CONFIG_NET_VENDOR_RACAL=y
> CONFIG_NI5010=m
> CONFIG_NI52=m
> CONFIG_NI65=m
> CONFIG_AT1700=m
> CONFIG_DEPCA=m
> CONFIG_HP100=m
> CONFIG_NET_ISA=y
> CONFIG_E2100=m
> CONFIG_EWRK3=m
> CONFIG_EEXPRESS=m
> CONFIG_EEXPRESS_PRO=m
> CONFIG_HPLAN_PLUS=m
> CONFIG_HPLAN=m
> CONFIG_LP486E=m
> CONFIG_ETH16I=m
> CONFIG_NE2000=m
> CONFIG_NET_PCI=y
> CONFIG_PCNET32=y
> CONFIG_ADAPTEC_STARFIRE=m
> CONFIG_AC3200=m
> CONFIG_APRICOT=m
> CONFIG_CS89x0=m
> CONFIG_TULIP=m
> # CONFIG_TULIP_MWI is not set
> # CONFIG_TULIP_MMIO is not set
> CONFIG_DE4X5=m
> CONFIG_DGRS=m
> CONFIG_DM9102=m
> CONFIG_EEPRO100=m
> # CONFIG_LNE390 is not set
> CONFIG_FEALNX=y
> CONFIG_NATSEMI=m
> # CONFIG_NATSEMI_CABLE_MAGIC is not set
> CONFIG_NE2K_PCI=y
> # CONFIG_NE3210 is not set
> # CONFIG_ES3210 is not set
> CONFIG_8139CP=y
> CONFIG_8139TOO=y
> # CONFIG_8139TOO_PIO is not set
> # CONFIG_8139TOO_TUNE_TWISTER is not set
> CONFIG_8139TOO_8129=y
> # CONFIG_8139_NEW_RX_RESET is not set
> CONFIG_SIS900=y
> CONFIG_EPIC100=m
> CONFIG_SUNDANCE=m
> CONFIG_TLAN=m
> CONFIG_VIA_RHINE=m
> # CONFIG_VIA_RHINE_MMIO is not set
> CONFIG_WINBOND_840=y
> CONFIG_NET_POCKET=y
> CONFIG_ATP=m
> CONFIG_DE600=m
> CONFIG_DE620=m
> 
> ****** FIM DO .config *********
> 
> Alguém sabe qual a solução?
> 
> Abraços.
> Paulo
> 
> 
> -- 
> To UNSUBSCRIBE, email to debian-user-portuguese-request@lists.debian.org
> with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
> 


-- 
Alexandre Martani
amartani em uol com br

Ainda usando Rwindow$ + Internet Exploder + Outloco Expresso?
Mude!

GNU/Linux + Mozilla Firefox + Sylpheed
Reply to: