wolny transfer-czytniki pamieci usb 2.0
witam, o co chodzi ? kupilem sobie czytnik pamieci do kilku rodzajow
kosci, wszystko chodzi, tylko dlaczego tak wolno ? po podlaczeniu
usb 2-1: new full speed USB device using uhci_hcd and address 2
usb 2-1: configuration #1 chosen from 1 choice
SCSI subsystem initialized
Initializing USB Mass Storage driver...
scsi0 : SCSI emulation for USB Mass Storage devices
usb-storage: device found at 2
usb-storage: waiting for device to settle before scanning
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
Vendor: Generic Model: USB SD Reader Rev: 1.00
Type: Direct-Access ANSI SCSI revision: 00
Vendor: Generic Model: USB CF Reader Rev: 1.01
Type: Direct-Access ANSI SCSI revision: 00
Vendor: Generic Model: USB SM Reader Rev: 1.02
Type: Direct-Access ANSI SCSI revision: 00
Vendor: Generic Model: USB MS Reader Rev: 1.03
Type: Direct-Access ANSI SCSI revision: 00
usb-storage: device scan complete
SCSI device sda: 1984000 512-byte hdwr sectors (1016 MB)
sda: Write Protect is off
sda: Mode Sense: 03 00 00 00
sda: assuming drive cache: write through
SCSI device sda: 1984000 512-byte hdwr sectors (1016 MB)
sda: Write Protect is off
sda: Mode Sense: 03 00 00 00
sda: assuming drive cache: write through
sda: sda1
sd 0:0:0:0: Attached scsi removable disk sda
sd 0:0:0:1: Attached scsi removable disk sdb
sd 0:0:0:2: Attached scsi removable disk sdc
sd 0:0:0:3: Attached scsi removable disk sdd
i polecenie mount -t vfat -o quiet,dmask=077,fmask=177,sync
/dev/sda1 /mnt/usbdrive
transfer jest rzędu 300-400 z kompa do pamięci, sprawdzilem w
łindołsie bo myslałem ze czytnik sieknęty jest , ale tam wszystko
chodzi orajt :/ . Podobnie jest z kopiowaniem danych przez palmtopa
na karte, w debianie chodzi to tragicznie, czyżbym nie wykorzystywal
złacza USB 2.0 ? nie mam pojecia gdzie szukac :/ prosze mnie
naprowadzic na jakiś trop...
dzieki
Reply to: