Re: Treiber für wlan rt2500
Am 04.07.2011 15:16, schrieb Gerhard Brandenburg:
> deb-amilo:~# lspci
> <snip>
> 00:0b.0 Network controller: RaLink RT2500 802.11g Cardbus/mini-PCI (rev 01)
Hallo Gerhard,
ich habe nun einen alten Laptop mit 2.6.26-2-686 hervorgekramt
und eine Conceptronic C54RC Version 2.0 54Mbps Wireless PC Card (PCMCIA)
habe ich nun unter 2.6.26-2-686 mit WPA2 am laufen.
GENAU die von dir beschriebene und gewünschte Konstellation.
Im folgenden findest du die Ausgaben von
sudo lspci -v
uname -a
sudo modinfo rt2500pci
dmesg nach dem Einstecken
cat /etc/network/interfaces
cat /etc/wpa_supplicant/wpa_supplicant.conf
sudo iwlist wlan0 scan
sudo iwconfig wlan0
sudo ifconfig -a
ping www.google.de
eigentlich alles was mir einfällt, wie ich dir noch weiter helfen kann.
HTH Andy
lspci -v:
02:00.0 Network controller: RaLink RT2500 802.11g Cardbus/mini-PCI (rev 01)
Subsystem: Device 1948:3c00
Flags: bus master, slow devsel, latency 64, IRQ 11
Memory at 24000000 (32-bit, non-prefetchable) [size=8K]
Capabilities: [40] Power Management version 2
Kernel driver in use: rt2500pci
andy@geribabe:~$ uname -a
Linux geribabe 2.6.26-2-686 #1 SMP Thu Mar 26 01:08:11 UTC 2009 i686
GNU/Linux
andy@geribabe:~$ sudo modinfo rt2500pci
filename:
/lib/modules/2.6.26-2-686/kernel/drivers/net/wireless/rt2x00/rt2500pci.ko
license: GPL
description: Ralink RT2500 PCI & PCMCIA Wireless LAN driver.
version: 2.1.4
author: http://rt2x00.serialmonkey.com
srcversion: 79AAF531526CE6FAE8C7D23
alias: pci:v00001814d00000201sv*sd*bc*sc*i*
depends: rt2x00lib,rt2x00pci,eeprom_93cx6
vermagic: 2.6.26-2-686 SMP mod_unload modversions 686
Karte einstecken, dmesg
[ 1366.952084] pccard: CardBus card inserted into slot 0
[ 1366.952486] rt2500pci 0000:02:00.0: enabling device (0000 -> 0002)
[ 1366.952509] ACPI: PCI Interrupt 0000:02:00.0[A] -> Link [LNKB] -> GSI
11 (level, low) -> IRQ 11
[ 1366.952526] PCI: Setting latency timer of device 0000:02:00.0 to 64
[ 1366.977403] phy1: Selected rate control algorithm 'pid'
[ 1366.978955] Registered led device: rt2500pci-phy1:radio
[ 1368.148641] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 1370.152540] wlan0: Initial auth_alg=0
[ 1370.152561] wlan0: authenticate with AP 00:21:29:99:37:85
[ 1370.154084] wlan0: RX authentication from 00:21:29:99:37:85 (alg=0
transaction=2 status=0)
[ 1370.154101] wlan0: authenticated
[ 1370.154108] wlan0: associate with AP 00:21:29:99:37:85
[ 1370.156483] wlan0: RX AssocResp from 00:21:29:99:37:85 (capab=0x431
status=0 aid=2)
[ 1370.156483] wlan0: associated
[ 1370.156483] wlan0: failed to set TX queue parameters for queue 2
[ 1370.156483] wlan0: failed to set TX queue parameters for queue 3
[ 1370.156483] wlan0: switched to short barker preamble
(BSSID=00:21:29:99:37:85)
[ 1370.156483] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[ 1380.388035] wlan0: no IPv6 routers present
andy@geribabe:~$ cat /etc/network/interfaces
# The loopback network interface
auto lo
iface lo inet loopback
auto wlan0
allow-hotplug wlan0
iface wlan0 inet static
address 192.168.2.6
netmask 255.255.255.0
gateway 192.168.2.1
wpa-conf /etc/wpa_supplicant/wpa_supplicant.conf
andy@geribabe:~$ cat /etc/wpa_supplicant/wpa_supplicant.conf
ctrl_interface=/var/run/wpa_supplicant
eapol_version=1
network={
ssid="dd-wrt_vap"
scan_ssid=0
proto=RSN
key_mgmt=WPA-PSK
pairwise=CCMP
group=CCMP
#psk="mein schluessel"
psk=hey schluessel, mit wpa_passphrase erstellt
}
andy@geribabe:~$ sudo iwlist wlan0 scan
wlan0 Scan completed :
Cell 01 - Address: 00:21:29:99:37:85
ESSID:"dd-wrt_vap"
Mode:Master
Channel:2
Frequency:2.417 GHz (Channel 2)
Quality=48/100 Signal level=-67 dBm
Encryption key:on
IE: IEEE 802.11i/WPA2 Version 1
Group Cipher : CCMP
Pairwise Ciphers (1) : CCMP
Authentication Suites (1) : PSK
Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s; 18 Mb/s
24 Mb/s; 36 Mb/s; 54 Mb/s; 6 Mb/s; 9 Mb/s
12 Mb/s; 48 Mb/s
Extra:tsf=00000000342ab525
andy@geribabe:~$ sudo iwconfig wlan0
wlan0 IEEE 802.11 ESSID:"dd-wrt_vap"
Mode:Managed Frequency:2.417 GHz Access Point:
00:21:29:99:37:85
Bit Rate=1 Mb/s Tx-Power=20 dBm
Retry min limit:7 RTS thr:off Fragment thr=2352 B
Encryption key:D3D4-4CB5-CAD5-3EB3-12A7-5033-718F-E617 [3]
Link Quality=49/100 Signal level=-53 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
andy@geribabe:~$ sudo ifconfig -a
eth0 Link encap:Ethernet Hardware Adresse 68:00:00:24:18:08
UP BROADCAST MULTICAST MTU:1500 Metrik:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
Kollisionen:0 Sendewarteschlangenl�nge:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interrupt:10 Basisadresse:0xd000
lo Link encap:Lokale Schleife
inet Adresse:127.0.0.1 Maske:255.0.0.0
inet6-Adresse: ::1/128 G�ltigkeitsbereich:Maschine
UP LOOPBACK RUNNING MTU:16436 Metrik:1
RX packets:30 errors:0 dropped:0 overruns:0 frame:0
TX packets:30 errors:0 dropped:0 overruns:0 carrier:0
Kollisionen:0 Sendewarteschlangenl�nge:0
RX bytes:2764 (2.6 KiB) TX bytes:2764 (2.6 KiB)
wlan0 Link encap:Ethernet Hardware Adresse 00:80:5a:34:67:16
inet Adresse:192.168.2.6 Bcast:192.168.2.255 Maske:255.255.255.0
inet6-Adresse: fe80::280:5aff:fe34:6716/64
G�ltigkeitsbereich:Verbindung
UP BROADCAST RUNNING MULTICAST MTU:1500 Metrik:1
RX packets:1260 errors:0 dropped:0 overruns:0 frame:0
TX packets:755 errors:0 dropped:0 overruns:0 carrier:0
Kollisionen:0 Sendewarteschlangenl�nge:1000
RX bytes:403652 (394.1 KiB) TX bytes:137014 (133.8 KiB)
wmaster0 Link encap:UNSPEC Hardware Adresse
00-80-5A-34-67-16-77-6C-00-00-00-00-00-00-00-00
UP BROADCAST RUNNING MULTICAST MTU:1500 Metrik:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
Kollisionen:0 Sendewarteschlangenl�nge:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
andy@geribabe:~$ ping www.google.de
PING www.l.google.com (209.85.148.103) 56(84) bytes of data.
64 bytes from fra07s07-in-f103.1e100.net (209.85.148.103): icmp_seq=1
ttl=57 time=49.9 ms
64 bytes from fra07s07-in-f103.1e100.net (209.85.148.103): icmp_seq=2
ttl=57 time=49.9 ms
Reply to: