Re: Lenny, Kernel 2.6.25/26, IDE, BX-Chipsatz, I/O Error
Am 30.08.2008 14:13, Sven Hartge schrieb:
> "S. Pfeffer" <lists@worom.net> wrote:
>> Hallo Liste,
>
>> nachdem Kernelupdate auf 2.6.26 meinte das System es sollte nach 194
>> Tagen mal wieder einen fscheck machen. Soweit ganz normal. Dann gab es
>> jedoch mehrfach folgende Fehlermeldung:
>
>> ide: failed opcode was: unknown
>> end requst: I/O error, dev hda, sector xxxxx
>> Buffer I/O error on device hda8 logical block xxxx
>> hda: dma_intr: status=0x51 { DriveReady SeekComplete Error }
>> hda: dma_intr: status=0x40 { UncorrectableError } LBAsect=xxxx, sector=xxxx
>
> Die Aussage UncorrectableError kommt direkt von der Platte und ist
> keine, die der Kernel erfindet.
Warum gibt es dann keine Fehlermeldung bei dem SuSE Rescuesystem?
Gut, die Platte ist uralt und machts wohl eh nicht mehr lange.
> Was sagt smartctl -t long /dev/hda ?
OK, ein Hinweis, ich werde wohl erstmal die Firmware upgraden wie es
smartctl sagt.
---command output---
smartctl -t long /dev/hda
smartctl version 5.38 [i686-pc-linux-gnu] Copyright (C) 2002-8 Bruce Allen
Home page is http://smartmontools.sourceforge.net/
=== START OF OFFLINE IMMEDIATE AND SELF-TEST SECTION ===
Sending command: "Execute SMART Extended self-test routine immediately
in off-line mode".
Drive command "Execute SMART Extended self-test routine immediately in
off-line mode" successful.
Testing has begun.
Please wait 15 minutes for test to complete.
Test will complete after Sun Aug 31 02:15:16 2008
Use smartctl -X to abort test.
smartctl --all /dev/hda
smartctl version 5.38 [i686-pc-linux-gnu] Copyright (C) 2002-8 Bruce Allen
Home page is http://smartmontools.sourceforge.net/
=== START OF INFORMATION SECTION ===
Model Family: IBM Deskstar 40GV & 75GXP series (all other firmware)
Device Model: IBM-DTLA-305020
Serial Number: YE0YELT6577
Firmware Version: TW2OA60A
User Capacity: 20.576.747.520 bytes
Device is: In smartctl database [for details use: -P show]
ATA Version is: 5
ATA Standard is: ATA/ATAPI-5 T13 1321D revision 1
Local Time is: Sun Aug 31 02:21:04 2008 CEST
==> WARNING: IBM Deskstar 40GV and 75GXP drives may need upgraded SMART
firmware.
Please see http://www.geocities.com/dtla_update/ and
http://www-3.ibm.com/pc/support/site.wss/document.do?lndocid=MIGR-42215 or
http://www-1.ibm.com/support/docview.wss?uid=psg1MIGR-42215
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x00) Offline data collection activity
was never started.
Auto Offline Data Collection:
Disabled.
Self-test execution status: ( 116) The previous self-test completed
having
the read element of the test failed.
Total time to complete Offline
data collection: (1559) seconds.
Offline data collection
capabilities: (0x1b) SMART execute Offline immediate.
Auto Offline data collection
on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
No Conveyance Self-test supported.
No Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
No General Purpose Logging support.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: ( 15) minutes.
SMART Attributes Data Structure revision number: 16
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE
UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000b 099 099 060 Pre-fail Always
- 131072
2 Throughput_Performance 0x0005 100 100 050 Pre-fail
Offline - 0
3 Spin_Up_Time 0x0007 101 101 024 Pre-fail Always
- 125 (Average 131)
4 Start_Stop_Count 0x0012 100 100 000 Old_age Always
- 1004
5 Reallocated_Sector_Ct 0x0033 100 100 005 Pre-fail Always
- 0
7 Seek_Error_Rate 0x000b 100 100 067 Pre-fail Always
- 0
8 Seek_Time_Performance 0x0005 100 100 020 Pre-fail
Offline - 0
9 Power_On_Hours 0x0012 094 094 000 Old_age Always
- 47001
10 Spin_Retry_Count 0x0013 100 100 060 Pre-fail Always
- 0
12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always
- 1001
192 Power-Off_Retract_Count 0x0032 100 100 050 Old_age Always
- 1004
193 Load_Cycle_Count 0x0012 100 100 050 Old_age Always
- 1004
194 Temperature_Celsius 0x0002 250 250 000 Old_age Always
- 22
196 Reallocated_Event_Count 0x0032 100 100 000 Old_age Always
- 0
197 Current_Pending_Sector 0x0022 100 100 000 Old_age Always
- 1
198 Offline_Uncorrectable 0x0008 100 100 000 Old_age
Offline - 0
199 UDMA_CRC_Error_Count 0x000a 200 200 000 Old_age Always
- 0
SMART Error Log Version: 1
ATA Error Count: 240 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 240 occurred at disk power-on lifetime: 46971 hours (1957 days + 3
hours)
When the command that caused the error occurred, the device was active
or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 98 fb 70 8f e1 Error: UNC 152 sectors at LBA = 0x018f70fb =
26177787
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 98 fb 70 8f e1 00 1d+00:50:15.300 READ DMA
c8 00 9a f9 70 8f e1 00 1d+00:50:09.500 READ DMA
c8 00 9c f7 70 8f e1 00 1d+00:50:03.600 READ DMA
c8 00 9e f5 70 8f e1 00 1d+00:49:57.700 READ DMA
c8 00 a0 f3 70 8f e1 00 1d+00:49:50.800 READ DMA
Error 239 occurred at disk power-on lifetime: 46971 hours (1957 days + 3
hours)
When the command that caused the error occurred, the device was active
or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 98 fb 70 8f e1 Error: UNC 152 sectors at LBA = 0x018f70fb =
26177787
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 9a f9 70 8f e1 00 1d+00:50:09.500 READ DMA
c8 00 9c f7 70 8f e1 00 1d+00:50:03.600 READ DMA
c8 00 9e f5 70 8f e1 00 1d+00:49:57.700 READ DMA
c8 00 a0 f3 70 8f e1 00 1d+00:49:50.800 READ DMA
c8 00 a2 f1 70 8f e1 00 1d+00:49:45.000 READ DMA
Error 238 occurred at disk power-on lifetime: 46971 hours (1957 days + 3
hours)
When the command that caused the error occurred, the device was active
or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 98 fb 70 8f e1 Error: UNC 152 sectors at LBA = 0x018f70fb =
26177787
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 9c f7 70 8f e1 00 1d+00:50:03.600 READ DMA
c8 00 9e f5 70 8f e1 00 1d+00:49:57.700 READ DMA
c8 00 a0 f3 70 8f e1 00 1d+00:49:50.800 READ DMA
c8 00 a2 f1 70 8f e1 00 1d+00:49:45.000 READ DMA
c8 00 a4 ef 70 8f e1 00 1d+00:49:39.100 READ DMA
Error 237 occurred at disk power-on lifetime: 46971 hours (1957 days + 3
hours)
When the command that caused the error occurred, the device was active
or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 98 fb 70 8f e1 Error: UNC 152 sectors at LBA = 0x018f70fb =
26177787
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 9e f5 70 8f e1 00 1d+00:49:57.700 READ DMA
c8 00 a0 f3 70 8f e1 00 1d+00:49:50.800 READ DMA
c8 00 a2 f1 70 8f e1 00 1d+00:49:45.000 READ DMA
c8 00 a4 ef 70 8f e1 00 1d+00:49:39.100 READ DMA
c8 00 a6 ed 70 8f e1 00 1d+00:49:33.200 READ DMA
Error 236 occurred at disk power-on lifetime: 46971 hours (1957 days + 3
hours)
When the command that caused the error occurred, the device was active
or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 98 fb 70 8f e1 Error: UNC 152 sectors at LBA = 0x018f70fb =
26177787
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 a0 f3 70 8f e1 00 1d+00:49:50.800 READ DMA
c8 00 a2 f1 70 8f e1 00 1d+00:49:45.000 READ DMA
c8 00 a4 ef 70 8f e1 00 1d+00:49:39.100 READ DMA
c8 00 a6 ed 70 8f e1 00 1d+00:49:33.200 READ DMA
c8 00 a8 eb 70 8f e1 00 1d+00:49:27.300 READ DMA
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining
LifeTime(hours) LBA_of_first_error
# 1 Extended offline Completed: read failure 40% 47001
26177787
# 2 Extended offline Completed: read failure 40% 38586
26177787
Device does not support Selective Self Tests/Logging
> S°
>
Reply to: