1und1 rootie Festplatte trotz UDMA zu langsam
Hallo,
ich habe ein Problem mit dem 1und1 Root-Server L der 2003 generation.
40 GB Festplatte IDE-VT82Cxx
Trotz udma kommt der nicht aus dem Sessel.
# hdparm -tT /dev/hda/dev/hda:
Timing buffer-cache reads: 416 MB in 2.00 seconds = 208.00 MB/sec
Timing buffered disk reads: 12 MB in 3.28 seconds = 3.66 MB/sec
Die werte erscheinen mir etwas zu langsam.
0000:00:11.1 IDE interface: VIA Technologies, Inc. VT82C586A/B/VT82C686/A/B/VT823x/A/C PIPC Bus Master IDE (rev 06)
Ist einkompiliert. Allerdings verstehe ich nicht die Meldungen beim Start, Aber es scheint alles ok zu sein. Hier noch ein ausschnitt:
Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
VP_IDE: IDE controller at PCI slot 00:11.1
VP_IDE: chipset revision 6
VP_IDE: not 100% native mode: will probe irqs later
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
VP_IDE: VIA vt8235 (rev 00) IDE UDMA133 controller on pci00:11.1
ide0: BM-DMA at 0xdc00-0xdc07, BIOS settings: hda:DMA, hdb:pio
hda: IC35L040AVVA07-0, ATA DISK drive
blk: queue c036f360, I/O limit 4095Mb (mask 0xffffffff)
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: attached ide-disk driver.
hda: 80418240 sectors (41174 MB) w/1863KiB Cache, CHS=5005/255/63, UDMA(100)
Partition check:
hda: hda1 hda2 hda3 hda4 < hda5 hda6 hda7 hda8 >
NET4: Linux TCP/IP 1.0 for NET4.0
Hier noch dir ausgabe von hdparm:
p15150407:/usr/src/kernel-source-2.4.27# hdparm -tT /dev/hda
/dev/hda:
Timing buffer-cache reads: 416 MB in 2.00 seconds = 208.00 MB/sec
Timing buffered disk reads: 12 MB in 3.28 seconds = 3.66 MB/sec
p15150407:/usr/src/kernel-source-2.4.27# lspci
0000:00:00.0 Host bridge: VIA Technologies, Inc. P4M266 Host Bridge
0000:00:01.0 PCI bridge: VIA Technologies, Inc. VT8633 [Apollo Pro266 AGP]
0000:00:10.0 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 80)
0000:00:10.1 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 80)
0000:00:10.2 USB Controller: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller (rev 80)
0000:00:10.3 USB Controller: VIA Technologies, Inc. USB 2.0 (rev 82)
0000:00:11.0 ISA bridge: VIA Technologies, Inc. VT8235 ISA Bridge
0000:00:11.1 IDE interface: VIA Technologies, Inc. VT82C586A/B/VT82C686/A/B/VT823x/A/C PIPC Bus Master IDE (rev 06)
0000:00:12.0 Ethernet controller: VIA Technologies, Inc. VT6102 [Rhine-II] (rev 74)
0000:01:00.0 VGA compatible controller: S3 Inc. VT8375 [ProSavage8 KM266/KL266]
p15150407:/usr/src/kernel-source-2.4.27#
p15150407:/usr/src/kernel-source-2.4.27#
p15150407:/usr/src/kernel-source-2.4.27#
p15150407:/usr/src/kernel-source-2.4.27# hdparm -i /dev/hda
/dev/hda:
Model=IC35L040AVVA07-0, FwRev=VA2OA52A, SerialNo=VNC202A2JALMYG
Config={ HardSect NotMFM HdSw>15uSec Fixed DTR>10Mbs }
RawCHS=16383/16/63, TrkSize=0, SectSize=0, ECCbytes=52
BuffType=DualPortCache, BuffSize=1863kB, MaxMultSect=16, MultSect=16
CurCHS=16383/16/63, CurSects=16514064, LBA=yes, LBAsects=80418240
IORDY=on/off, tPIO={min:240,w/IORDY:120}, tDMA={min:120,rec:120}
PIO modes: pio0 pio1 pio2 pio3 pio4
DMA modes: mdma0 mdma1 mdma2
UDMA modes: udma0 udma1 udma2 udma3 *udma4 udma5
AdvancedPM=yes: disabled (255) WriteCache=enabled
Drive conforms to: ATA/ATAPI-5 T13 1321D revision 1:
Kann mir jemand helfen?
ps:Kernel 2.4.7
Reply to: