> Bonjour à tous,
> soit un serveur sur Etch avec une carte NetXtreme II BCM5708. Lors du boot,
> le pilote bx2 se charge bien mais pas moyen d'utiliser la carte réseau.
> ifconfig -a renvoi uniquement lo.
>
> Ce qui me parait particulièrement curieux, c'est que cette carte fonctionne
> avec l'ancien noyau bpo le 2.6.22 (mais j'ai un autre pb avec ce dernier).
>
> voila les info envoyées par lshw
> *-network
> description: Ethernet interface
> product: NetXtreme II BCM5708 Gigabit Ethernet
> vendor: Broadcom Corporation
> physical id: 0
> bus info: pci@03:00.0
> logical name: eth0
> version: 12
> serial: 00:1f:29:c8:21:bc
> size: 1GB/s
> capacity: 1GB/s
> width: 64 bits
> clock: 66MHz
> capabilities: bus_master cap_list ethernet physical tp
> 10bt 10bt-fd 100bt 100bt-fd 1000bt-fd autonegotiation
> configuration: autonegotiation=on broadcast=yes
> driver=bnx2 driverversion=1.5.11 duplex=full firmware=1.9.6 ip=
10.127.164.2
> latency=64 link=yes mingnt=64 multicast=yes port=twisted pair speed=1GB/s
> resources: iomemory:fa000000-fbffffff irq:16
>
>
> Voila, si quelqu'un a une idée.....