carte TV HAUPPAUGE HVR-1300
Source Kernel téléchargée 2.6.16 (20 mars) de www.kernel.org compilée et installée
Linux version 2.6.16 (root playtime) (gcc version 4.0.3 20060128
(prerelease) (Debian 4.0.2-8))
processor AMD ATHLON 64 : x86_64
téléchargement ~stoth/v4l-dvb sur www.linuxtv.org :
# hg clone http://www.linux.org/~stoth/v4l-dvb <http://www.linux.org/%7Estoth/v4l-dvb>
# cd v4l-dvb
# make
# make install
j'utilise tvtime mais
Pas de chaînes detectés
Ni analogique ni numerique
je reçois la TNT (NANTES)
Je cherche d'autres expériences de test sur cette carte avec le module fourni par Steve TOTH
--------------------------------------------------
Linux video capture interface: v1.00
ACPI: PCI Interrupt Link [APCJ] enabled at IRQ 22
ACPI: PCI Interrupt 0000:00:04.0[A] -> Link [APCJ] -> GSI 22 (level,
low) -> IRQ 17
PCI: Setting latency timer of device 0000:00:04.0 to 64
cx2388x alsa driver version 0.0.5 loaded
cx2388x 8802 Driver Manager version 0.0.5 loaded
intel8x0_measure_ac97_clock: measured 50546 usecs
intel8x0: clocking to 46808
ACPI: PCI Interrupt Link [APC1] enabled at IRQ 16
GSI 20 sharing vector 0xD1 and IRQ 20
ACPI: PCI Interrupt 0000:05:06.1[A] -> Link [APC1] -> GSI 16 (level,
low) -> IRQ 20 CORE cx88[0]: subsystem: 0070:9601, board: Hauppauge
WinTV-HVR1300 DVB-T/Hybrid MPEG Encoder [card=47,insmod option]
TV tuner 63 at 0x1fe, Radio tuner -1 at 0x1fe
tveeprom 2-0050: Hauppauge model 96019, rev C2A0, serial# 99649
tveeprom 2-0050: MAC address is 00-0D-FE-01-85-41
tveeprom 2-0050: tuner model is Philips FMD1216ME (idx 100, type 63)
tveeprom 2-0050: TV standards PAL(B/G) PAL(I) SECAM(L/L') PAL(D/D1/K)
ATSC/DVB Digital (eeprom 0xf4)
tveeprom 2-0050: audio processor is CX882 (idx 33)
tveeprom 2-0050: decoder processor is CX882 (idx 25)
tveeprom 2-0050: has radio, has IR remote
cx88[0]: hauppauge eeprom: model=96019
pnp: the driver 'mpu401' has been registered
pnp: match found with the PnP device '00:0a' and the driver 'mpu401'
cx88[0]/1: CX88x/0: ALSA support for cx2388x boards
cx88[0]/2: cx2388x 8802 Driver Manager
ACPI: PCI Interrupt 0000:05:06.2[A] -> Link [APC1] -> GSI 16 (level,
low) -> IRQ 20 cx88[0]/2: found at 0000:05:06.2, rev: 5, irq: 20,
latency: 32, mmio: 0xda000000
cx2388x v4l2 driver version 0.0.5 loaded
ACPI: PCI Interrupt 0000:05:06.0[A] -> Link [APC1] -> GSI 16 (level,
low) -> IRQ 20 cx88[0]/0: found at 0000:05:06.0, rev: 5, irq: 20,
latency: 32, mmio: 0xd8000000
pnp: the driver 'parport_pc' has been registered
pnp: match found with the PnP device '00:09' and the driver 'parport_pc'
parport: PnPBIOS parport detected.
parport0: PC-style at 0x378 (0x778), irq 7, dma 3
[PCSPP,TRISTATE,COMPAT,ECP,DMA]
tuner 2-0061: chip found @ 0xc2 (cx88[0])
tuner 2-0061: type set to 63 (Philips FMD1216ME MK3 Hybrid Tuner)
tuner 2-0063: chip found @ 0xc6 (cx88[0])
acx: this driver is still EXPERIMENTAL
acx: reading README file and/or Craig's HOWTO is recommended, visit
http://acx100.sf.net in case of further questions/discussion acx:
compiled to use 32bit I/O access. I/O timing issues might occur, such as
non-working firmware upload. Report them
running on a little-endian CPU
PCI module v0.3.21 initialized, waiting for cards to probe...
tda9887 2-0043: chip found @ 0x86 (cx88[0])
cx88[0]/0: registered device video0 [v4l2]
cx88[0]/0: registered device vbi0
cx88[0]/0: registered device radio0
Reply to: