Problème avec le Wifi

[fra-duf-no-spam@tourde.org (François TOURDE)]

Salut,

Je viens de recevoir mon nouveau AP Wifi, l'ancien ayant grillé, mais
maintenant j'ai un autre souci.

ifplugd ne reconnait pas la présence de l'interface et de la liaison
Wireless. Ma carte (driver prism54) est up, iwscan eth1 list me donne
bien la présence d'un AP, mais ifplugstatus ne voit pas le link beat.

Infos:

fermat:~# ifplugstatus -v eth1
eth1:
    SIOCETHTOOL failed (Operation not supported)
    SIOCGMIIPHY failed (Operation not supported)
    Wireless: unplugged
    IFF_RUNNING: link beat detected
    SIOCDEVPRIVATE failed (Operation not supported)

fermat:~# iwconfig eth1
eth1      IEEE 802.11b/g  Mode:Managed  Frequency:2.432 GHz  
          Access Point: 00:00:00:00:00:00   Bit Rate:0 kb/s   Tx-Power=31 dBm   
          Sensitivity=20/200  
          Retry min limit:8   RTS thr:2347 B   Fragment thr:2346 B   
          Encryption key:off
          Link Quality:15  Signal level:0  Noise level:0
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0

fermat:~# iwlist eth1 scan
eth1      Scan completed :
          Cell 01 - Address: 00:0F:66:11:74:3D
                    ESSID:"Tourde-WAP54G"
                    Mode:Master
                    Encryption key:on
                    Frequency:2.462 GHz (Channel 11)
                    Quality:246/0  Signal level:-51 dBm  Noise level:-41 dBm

Des idées ?

Merci d'avance.

-- 
The next person to mention spaghetti stacks to me is going to have
his head knocked off.
		-- Bill Conrad