[MODEM USB TCM290] Impossible de se connecter
Bonjour,
Depuis une semaine, je ne peux plus me connecter avec mon modem cable
Thomson TCM290, en mode Ethernet. Je n'ai pas encore trouvé où se
situait le problème.
En attendant, je souhaite me connecter en mode USB. Mais, je n'y arrive pas.
Je vous donne plusieurs de mes fichiers log et de config.
J'espère que quelqu'un trouvera d'où viens de problème, car moi, ça fait
une semaine, et je ne vois pas.
Merci d'avance, pour tout ceux qui se pencheront sur mon problème.
/etc/network/interfaces:_
_*****************
# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).
# This entry denotes the loopback (127.0.0.1) interface.
auto lo
iface lo inet loopback
# This entry was created during the Debian installation
# (network, broadcast and gateway are optional)
auto eth0
iface eth0 inet static
address 192.168.1.1
netmask 255.255.255.0
network 192.168.1.0
# broadcast 192.168.1.255
# gateway 192.168.1.1
auto eth1
iface eth1 inet dhcp
ifconfig
******
eth0 Lien encap:Ethernet HWaddr 00:09:5B:E0:3F:29
inet adr:192.168.1.1 Bcast:192.168.1.255 Masque:255.255.255.0
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 lg file transmission:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interruption:18 Adresse de base:0xc000
eth1 Lien encap:Ethernet HWaddr 00:10:95:9E:AF:0D
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:20 errors:0 dropped:0 overruns:0 frame:0
TX packets:30 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 lg file transmission:1000
RX bytes:1200 (1.1 KiB) TX bytes:720 (720.0 b)
lo Lien encap:Boucle locale
inet adr:127.0.0.1 Masque:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:84 errors:0 dropped:0 overruns:0 frame:0
TX packets:84 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 lg file transmission:0
RX bytes:5320 (5.1 KiB) TX bytes:5320 (5.1 KiB)
/etc/init.d/networking start_
_********************
Setting up IP spoofing protection: rp_filter.
Configuring network interfaces...Internet Software Consortium DHCP
Client 2.0pl5
Copyright 1995, 1996, 1997, 1998, 1999 The Internet Software Consortium.
All rights reserved.
Please contribute if you find this software useful.
For info, please visit http://www.isc.org/dhcp-contrib.html
Listening on LPF/eth1/00:10:95:9e:af:0d
Sending on LPF/eth1/00:10:95:9e:af:0d
Sending on Socket/fallback/fallback-net
DHCPDISCOVER on eth1 to 255.255.255.255 port 67 interval 8
DHCPDISCOVER on eth1 to 255.255.255.255 port 67 interval 14
DHCPDISCOVER on eth1 to 255.255.255.255 port 67 interval 18
DHCPDISCOVER on eth1 to 255.255.255.255 port 67 interval 14
DHCPDISCOVER on eth1 to 255.255.255.255 port 67 interval 6
No DHCPOFFERS received.
No working leases in persistent database.
Exiting.
Failed to bring up eth1.
done.
/var/log/ppp.log
************
Jul 14 15:35:33 localhost pppd[726]: pppd 2.4.2 started by root, uid 0
Jul 14 15:35:34 localhost pppd[726]: Serial connection established.
Jul 14 15:35:34 localhost pppd[726]: Using interface ppp0
Jul 14 15:35:34 localhost pppd[726]: Connect: ppp0 <--> /dev/pts/0
Jul 14 15:36:05 localhost pppd[726]: LCP: timeout sending Config-Requests
Jul 14 15:36:05 localhost pppd[726]: Connection terminated.
Jul 14 15:36:35 localhost pppd[726]: Serial connection established.
Jul 14 15:36:35 localhost pppd[726]: Using interface ppp0
Jul 14 15:36:35 localhost pppd[726]: Connect: ppp0 <--> /dev/pts/1
Jul 14 15:37:06 localhost pppd[726]: LCP: timeout sending Config-Requests
Jul 14 15:37:06 localhost pppd[726]: Connection terminated.
dmesg
*****
eth0: NatSemi DP8381[56] at 0xe086c000, 00:09:5b:e0:3f:29, IRQ 18.
SCSI subsystem driver Revision: 1.00
scsi0 : SCSI host adapter emulation for IDE ATAPI devices
Via 686a/8233/8235 audio driver 1.9.1-ac3
via82cxxx: Six channel audio available
PCI: Setting latency timer of device 00:11.5 to 64
ac97_codec: AC97 codec, id: ALG96 (Unknown)
via82cxxx: Codec rate locked at 48Khz
via82cxxx: board #1 at 0xE400, IRQ 22
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
usb-uhci.c: $Revision: 1.275 $ time 20:27:23 Apr 14 2004
usb-uhci.c: High bandwidth mode enabled
usb-uhci.c: USB UHCI at I/O 0xd400, IRQ 21
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
usb-uhci.c: USB UHCI at I/O 0xd800, IRQ 21
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 2
hub.c: USB hub found
hub.c: 2 ports detected
usb-uhci.c: USB UHCI at I/O 0xdc00, IRQ 21
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 3
hub.c: USB hub found
hub.c: 2 ports detected
usb-uhci.c: USB UHCI at I/O 0xe000, IRQ 21
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 4
hub.c: USB hub found
hub.c: 2 ports detected
usb-uhci.c: v1.275:USB Universal Host Controller Interface driver
ehci_hcd 00:10.4: VIA Technologies, Inc. USB 2.0
ehci_hcd 00:10.4: irq 21, pci mem e0905000
usb.c: new USB bus registered, assigned bus number 5
ehci_hcd 00:10.4: USB 2.0 enabled, EHCI 1.00, driver 2003-Dec-29/2.4
hub.c: USB hub found
hub.c: 8 ports detected
hub.c: new USB device 00:10.3-2, assigned address 2
usb.c: USB device 2 (vend/prod 0x46d/0xc00b) is not claimed by any
active driver.
eth0: autonegotiation did not complete in 4000 usec.
CDCEther.c: CDCEther.c: 0.98.6 7 Jan 2002 Brad Hards and another
usb.c: registered new driver CDCEther
hub.c: new USB device 00:10.0-2, assigned address 2
CDCEther.c: Ethernet information found at device configuration. Trying
to use it anyway.
CDCEther.c: Found Header descriptor, CDC version 110.
CDCEther.c: Imperfect filtering support - need sw hashing
CDCEther.c: Can't use SetEthernetMulticastFilters request
CDCEther.c: detected BULK OUT packets of size 64
CDCEther.c: interrupt address: 5
CDCEther.c: interrupt interval: 64
CDCEther.c: eth1: Thomson Consumer Electronics Thomson TCM290 Cable
Modem 0010959EAF0D
CDCEther.c: eth1: 00:10:95:9E:AF:0D
CSLIP: code copyright 1989 Regents of the University of California
PPP generic driver version 2.4.2
usb.c: registered new driver hiddev
usb.c: registered new driver hid
input: USB HID v1.10 Mouse [Logitech USB Mouse] on usb4:2.0
hid-core.c: v1.8.1 Andreas Gal, Vojtech Pavlik <vojtech@suse.cz>
hid-core.c: USB HID support drivers
CDCEther.c: CDCEther_open failed intr_urb -22
CDCEther.c: eth1: set multicast filters
CDCEther.c: eth1: set multicast filters
mice: PS/2 mouse device common for all mice
usb.c: registered new driver acm
acm.c: v0.21:USB Abstract Control Model driver for USB modems and ISDN
adapters
ip_tables: (C) 2000-2002 Netfilter core team
apm: BIOS version 1.2 Flags 0x07 (Driver version 1.16)
CDCEther.c: eth1: set multicast filters
CDCEther.c: eth1: set multicast filters
CDCEther.c: eth1: set multicast filters
CDCEther.c: eth1: set multicast filters
CDCEther.c: eth1: set multicast filters
CDCEther.c: eth1: set multicast filters
CDCEther.c: eth1: set multicast filters
CDCEther.c: eth1: set multicast filters
CDCEther.c: eth1: set multicast filters
Reply to: