pb carte flash
Je souhaite lire une carte mémoire d'un appareil photo numérique sur mon
portable et sous Debian 2.2
après avoir lu (survolé) le Kodak-HOWTO, le PCMCIA-HOWTO et trafiqué
/etc/pcmcia/ide.opts , voilà ce que me donne la commande dmesg.
Si vous pouvez m'aider, n'hésitez pas !
DAVID Thomas
Linux version 2.2.18pre21 (herbert@arnor) (gcc version 2.7.2.3) #1 Sat
Nov 18 18:47:15 EST 2000
Detected 233226 kHz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 465.30 BogoMIPS
Memory: 94704k/98304k available (1728k kernel code, 412k reserved, 1312k
data, 148k init)
Dentry hash table entries: 16384 (order 5, 128k)
Buffer cache hash table entries: 131072 (order 7, 512k)
Page cache hash table entries: 32768 (order 5, 128k)
VFS: Diskquotas version dquot_6.4.0 initialized
CPU: Intel Mobile Pentium MMX stepping 01
Checking 386/387 coupling... OK, FPU using exception 16 error reporting.
Checking 'hlt' instruction... OK.
Checking for popad bug... OK.
Intel Pentium with F0 0F bug - workaround enabled.
POSIX conformance testing by UNIFIX
PCI: PCI BIOS revision 2.10 entry at 0xf73ed
PCI: Using configuration type 1
PCI: Probing PCI hardware
Linux NET4.0 for Linux 2.2
Based upon Swansea University Computer Society NET3.039
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
TCP: Hash tables configured (ehash 131072 bhash 65536)
Starting kswapd v 1.5
Detected PS/2 Mouse Port.
pty: 256 Unix98 ptys configured
Real Time Clock Driver v1.09
RAM disk driver initialized: 16 RAM disks of 4096K size
loop: registered device at major 7
PCI_IDE: unknown IDE controller on PCI bus 00 device 71, VID=0e11,
DID=ae33
PCI_IDE: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0xb140-0xb147, BIOS settings: hda:pio, hdb:pio
PCI_IDE: simplex device: DMA disabled
ide1: PCI_IDE Bus-Master DMA disabled (BIOS)
hda: IBM-DPLA-25120, ATA DISK drive
hdb: COMPAQ CRD-S311, ATAPI CDROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: IBM-DPLA-25120, 4887MB w/468kB Cache, CHS=662/240/63
hdb: ATAPI 8X CD-ROM drive, 256kB Cache
Uniform CD-ROM driver Revision: 3.11
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
md driver 0.36.6 MAX_MD_DEV=4, MAX_REAL=8
scsi: <fdomain> Detection failed (no card)
NCR53c406a: no available ports found
sym53c416.c: Version 1.0.0
Failed initialization of WD-7000 SCSI card!
IBM MCA SCSI: Version 3.2
IBM MCA SCSI: No Microchannel-bus present --> Aborting.
This machine does not have any IBM MCA-bus
or the MCA-Kernel-support is not enabled!
megaraid: v1.11 (Aug 23, 2000)
aec671x_detect:
3w-xxxx: tw_findcards(): No cards found.
scsi : 0 hosts.
scsi : detected total.
Partition check:
hda: hda1 hda2 < hda5 hda6 >
apm: BIOS version 1.2 Flags 0x03 (Driver version 1.13)
apm: disabled on user request.
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 148k freed
NET4: Unix domain sockets 1.0 for Linux NET4.0.
Adding Swap: 98244k swap-space (priority -1)
IPv6 v0.8 for NET4.0
IPv6 over IPv4 tunneling driver
parport0: PC-style at 0x378 [SPP,PS2]
lp0: using parport0 (polling).
Soundblaster audio driver Copyright (C) by Hannu Savolainen 1993-1996
SB 3.01 detected OK (220)
ESS chip ES1878 detected
sb: Interrupt test on IRQ7 failed - Probable IRQ conflict
Serial driver version 4.27 with no serial options enabled
ttyS03 at 0x02e8 (irq = 3) is a 16550A
Linux PCMCIA Card Services 3.1.22
kernel build: 2.2.18pre21 unknown
options: [pci] [cardbus] [apm]
PCI routing table version 1.0 at 0xf9b30
unknown PCI interrupt router 0e11:ae29
Intel PCIC probe:
TI 1131 rev 01 PCI-to-CardBus at slot 00:0c, mem 0x7fffe000
host opts [0]: [pci + serial irq] [no pci irq] [lat 66/176] [bus
1/1]
host opts [1]: [pci + serial irq] [no pci irq] [lat 66/176] [bus
2/2]
ISA irqs (scanned) = 3,4,9,10,15 status change on irq 15
cs: IO port probe 0x0c00-0x0cff: excluding 0xc48-0xc4f 0xc68-0xc6f
0xcf8-0xcff
cs: IO port probe 0x0800-0x08ff: excluding 0x800-0x83f 0x850-0x87f
cs: IO port probe 0x0100-0x04ff: excluding 0x250-0x257 0x270-0x277
0x388-0x38f 0x408-0x40f 0x4d0-0x4d7
cs: IO port probe 0x0a00-0x0aff: clean.
cs: memory probe 0xa0000000-0xa0ffffff: clean.
xirc2ps_cs.c 1.31 1998/12/09 19:32:55 (dd9jn+kvh)
eth0: MII link partner: 05e1
eth0: MII selected
eth0: media 100BaseT, silicon revision 5
eth0: Xircom: port 0x300, irq 3, hwaddr 00:10:A4:03:B2:C5
tty02 at 0x03e8 (irq = 3) is a 16550A
eth0: MII link partner: 45e1
eth0: MII selected
eth0: media 100BaseT, silicon revision 5
hdc: SunDisk SDCFB-16, ATA DISK drive
ide2: ports already in use, skipping probe
ide1 at 0x100-0x107,0x10e on irq 9
hdc: SunDisk SDCFB-16, 15MB w/1kB Cache, CHS=490/2/32
hdc: hdc1
ide_cs: hdc: Vcc = 3.3, Vpp = 0.0
VFS: Disk change detected on device ide1(22,0)
hdc: hdc1
VFS: Disk change detected on device ide1(22,1)
hdc: hdc1
snort uses obsolete (PF_INET,SOCK_PACKET)
device eth0 entered promiscuous mode
eth0: no IPv6 routers present
CSLIP: code copyright 1989 Regents of the University of California
PPP: version 2.3.7 (demand dialling)
PPP line discipline registered.
Reply to: