Re: AVA-1505A, USB
Hi!
I have an AHA1505, (with an unsupported CDR unfortunately) I could
make it work by appending the parameter to the kernel on lilo boot (later
on lilo.conf.
This looks my lilo.conf
image = /boot/vmlinuz
append = "aha152x,7,5,0"
...
I'd suggest you to boot and append the parameters by hand, until you see
the scsi host is detected...
good luck!
On Fri, 12 Jan 2001, root wrote:
> 1)I read in the kernel helps that the SCSI driver for Adaptec aha152x
> can drive even the Adaptec AVA-1505 series.
> I can't make it run at all.
> Can some one, that had the same problem and resolved it, tell me how I
> must configure module or some other to make it run??
>
> 2)Somedoby kwnos if is it possible to make a point to point connection
> using the USB port??
> If yes, how I must do??
>
> Thank you vary much
>
> P.S. Excuse me for my bad english
>
>
>
Reply to: