AW: Harddisk 3.62 MB/sec
Hiho,
/dev/hda:
setting 32-bit IO_support flag to 3
setting unmaskirq to 1 (on)
setting using_dma to 1 (on)
setting xfermode to 133 (unknown, probably not valid)
HDIO_DRIVE_CMD(setxfermode) failed: Input/output error
IO_support = 3 (32-bit w/sync)
unmaskirq = 1 (on)
using_dma = 1 (on)
Thx for help
>You need this:
>hdparm -d1 -u1 -c3 -X133 /dev/hda
>It is a fact, that the drive is slow without dma...
>Regards,
>Csaba
On Tue, 19 Apr 2005 21:53:11 +0200, Philippe Braxmeier
<philippe.braxmeier@ph-solothurn.ch> wrote:
> Hello all!
> My Prob:
> hdparm -t /dev/hda
>
> /dev/hda:
> Timing buffered disk reads: 12 MB in 3.37 seconds = 3.56 MB/sec
>
> hdparm -T /dev/hda
>
> /dev/hda:
> Timing cached reads: 184 MB in 2.00 seconds = 91.97 MB/sec
>
> hdparm -i /dev/hda
>
> /dev/hda:
>
> Model=Maxtor 6B300R0, FwRev=BAH41BM0, SerialNo=B616NPQH Config={
> Fixed } RawCHS=16383/16/63, TrkSize=0, SectSize=0, ECCbytes=57
> BuffType=DualPortCache, BuffSize=16384kB, MaxMultSect=16, MultSect=off
> CurCHS=65535/1/63, CurSects=4128705, LBA=yes, LBAsects=268435455
> IORDY=on/off, tPIO={min:120,w/IORDY:120}, tDMA={min:120,rec:120} PIO
> modes: pio0 pio1 pio2 pio3 pio4 DMA modes: mdma0 mdma1 mdma2 UDMA
> modes: udma0 udma1 udma2 udma3 udma4 *udma5 udma6
> AdvancedPM=yes: disabled (255) WriteCache=enabled Drive conforms to:
> (null):
--
bitumen@tuxworld.homelinux.org
http://tuxworld.homelinux.org
Reply to: