ide-scsi problem with RICOH CD-R/RW MP7063A
After an upgrade from vmlinuz-2.4.20-3-k7 to vmlinuz-2.4.22-1-k7, I got
the following log entries (see below, in particular those marked by ->)
when booting/trying to use CD drive (both reading and writing). The
computer freezes, and I have to press the reset button.
I am using debian sarge, on a SiS motherboard with a duron processor.
Otherwise the system works fine, and I have tested both reading and
writing with 2.4.20 AFTER the problems, so it is unlikely a problem with
broken hardware.
- Nenad.
Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
ide: late registration of driver.
SIS5513: IDE controller at PCI slot 00:02.5
SIS5513: SiS735 ATA 100 (2nd gen) controller
ide0: BM-DMA at 0xff00-0xff07, BIOS settings: hda:DMA, hdb:DMA
ide1: BM-DMA at 0xff08-0xff0f, BIOS settings: hdc:DMA, hdd:DMA
hda: WDC WD400BB-00CCB0, ATA DISK drive
hdc: RICOH CD-R/RW MP7063A, ATAPI CD/DVD-ROM drive
-> hdc: set_drive_speed_status: status=0x51 { DriveReady SeekComplete Error }
-> hdc: set_drive_speed_status: error=0x04
hdc: attached ide-scsi driver.
scsi0 : SCSI host adapter emulation for IDE ATAPI devices
Vendor: RICOH Model: CD-R/RW MP7063A Rev: 1.80
Type: CD-ROM ANSI SCSI revision: 02
Attached scsi CD-ROM sr0 at scsi0, channel 0, id 0, lun 0
sr0: scsi3-mmc drive: 32x/32x writer cd/rw xa/form2 cdda tray
Uniform CD-ROM driver Revision: 3.12
Logs for the 2.4.20 kernel after that add a few more lines, and it WORKS:
ISO 9660 Extensions: Microsoft Joliet Level 3
ISOFS: changing to secondary root
Reply to: