woody/PowerMac 6400 - NIC driver install trouble

["Bruce A. Burdick, Jr." <bucky@interaccess.com>]

I'm trying to install woody on a PowerMac 6400 with an AsanteFAST 10/100
card, but having no luck. The NIC, which works fine in MacOS, isn't
recognized. The only driver that looks remotely suitable is the ng_tulip
driver (the Asante has a tulip chip, as I understand it). But that won't
install.

Here is an excerpt of the messages I get when I try to add ng_tulip to the
kernel using the installer interface:

/lib/modules/2.2.20-pmac/net/ng_tulip.o: init_module: Device or resource
busy
Hint: insmod errors can be caused by incorrect parameters, including invalid
IO or IRQ parameters
/lib/modules/2.2.20-pmac/net/ng_tulip.o: insmod
/lib/modules/2.2.20-pmac/net/ng_tulip.o failed
/lib/modules/2.2.20-pmac/net/ng_tulip.o: insmod ng_tulip failed

Installation failed.
depmod: *** Unresolved symbols in
/lib/modules/2.2.20-pmac/pcmcia/serial_cb.o
depmod: *** Unresolved symbols in
/lib/modules/2.2.20-pmac/pcmcia/serial_cs.o


Can anyone shed any light on this?

-B...